SUPPLEMENTAL RESTRAINTS – Lincoln Continental 2000 – SYSTEM WIRING DIAGRAMS

SUPPLEMENTAL RESTRAINTS

Supplemental Restraint Wiring Diagram for Lincoln Continental 2000

List of elements for Supplemental Restraint Wiring Diagram for Lincoln Continental 2000:

• 1 pin in-line connector, left side of vehicle, left side of driver seat) s314
• Air bag indicator
• Air bag indicator driver
• Air bag sliding contact
• C206
• C255
• C326
• C327
• C449
• Central junction box (below left side of dash)
• Data link (dlc)
• Data link connector (dlc) (partial) (at bottom c251
• Driver air bag
• Driver air bag feed
• Driver air bag return
• Driver side air bag (w/side airbags) resistor a (w/o side airbags)
• Driver side air bag feed
• Driver side air bag return
• Driver side sensor feed
• Driver side sensor return
• Driver's air bag crash sensor (under driver's seat)
• Fuse 5 10a
• Fuse 9 10a
• Fused ignition
• G900 (left "a" panel)
• Ground
• Hot in run
• Hot in run or start
• Left of dash)
• Lighting control module (lcm) (on left side of dash)
• Nca
• Pass air bag feed
• Pass air bag return
• Pass side air bag feed
• Pass side air bag return
• Pass side sensor feed
• Pass side sensor return
• Passenger air bag
• Passenger side air bag (w/side airbags) resistor b (w/o side airbags)
• Passenger's air bag crash sensor (under passenger's seat)
• Pin shorting bar is engaged when module connector is disconnected (shorting bar is connected between pins: 3-4, 6-7, 20-21 conn. c327 2-3 & 5-6 conn. c326)
• Remote emergency satellite cellular unit (rescu) module (in right rear of trunk)
• Rescu signal
• Restraints control module (rcm) (between seats, below center console)
• S227 (14a005 harness, near breakout to 10 pin in-line connector, left side of dash, near a pillar breakout to eatc module)
• Shorting bar
• Tone generator
• Virtual image instrument cluster