TRANSMISSION
Transmission Wiring Diagram for Nissan 300ZX 2+2 1994
List of elements for Transmission Wiring Diagram for Nissan 300ZX 2+2 1994:
- A/c
- A/t check ind.
- A/t control unit (on passenger floor board, under carpet)
- A/t fluid temp. sensor
- Ascd control unit (behind center console)
- Automatic trans- mission red
- Backup lights
- Closed throttle
- Cruise
- Data link connector (for consult) (below left side of i/p)
- Dropping resistor (right rear of engine compt)
- Eccs control module (behind center console)
- Eccs relay
- Fuse 10a
- Fuse block (left kick panel)
- Fuse k 10a
- G101 (right front fender)
- G112 (left side of engine)
- G200 (left kick panel)
- Hot at all times
- Hot in on or start
- Ind.
- Inhibitor switch (right side of trans- mission)
- Instrument cluster
- Kickdown switch (on bracket, above accelerator pedal)
- Line press. sol. valve
- Mass air flow sensor (near hood latch)
- Nca
- O.d. off ind.
- O/d clutch sol. valve
- Over- drive switch
- Pnk
- Relay box (forward of left front shock tower)
- Revolution sensor (left transmission)
- Shift sol. valve a
- Shift sol. valve b
- Speedometer
- System
- Tachometer
- Tcc sol. valve
- Throttle position sensor (on throttle body)
- Throttle position switch (on throttle body)
- Vehicle speed sensor
- W/ air bag
- W/o air bag
- Warning lamps
- Wot