INSTRUMENT CLUSTER
Instrument Cluster Wiring Diagram for Chevrolet Lumina APV 1995
List of elements for Instrument Cluster Wiring Diagram for Chevrolet Lumina APV 1995:
- (3.1l vin d) (front of engine)
- (3.8l vin l)
- (vin d) (vin l)
- 3.1l vin d
- 3.8l vin l
- A5 d13
- Abs lamp driver module (behind parking brake cable bracket)
- Accy
- Air bag ind.
- Anti- lock brakes
- Audio alarm module (right side of i/p)
- B nca
- Brake fluid level switch (rear of engine compt)
- Brake ind.
- Bulb test
- Coolant temp. gauge
- D15
- Daytime running lamps module (left side of i/p)
- Diagnostic energy reserve module (center of i/p)
- Electronic brake control module (left side of i/p)
- Electronic brake traction control module (ebtcm) (3.8l vin l only) (behind i/p, left of brake pedal bracket)
- Engine coolant temperature sender (rear of engine)
- Exterior lights system
- Fasten belts ind.
- Fuel gauge
- Fuel pump/ engine oil pressure switch (front of engine)
- Fuel sender assembly (in fuel tank)
- Fuse block
- G100 (front left fender)
- G120 (right side of engine)
- G125
- G125 (front of engine)
- G402 (above left rear wheel well)
- G900 (left "a" pillar)
- Gate ajar ind.
- Gauges fuse 7.5a
- Headlights system
- Hi beam ind.
- Hot in run, bulb
- Ignition switch
- Illum. lamps
- Instrument cluster
- Interior lights system
- Left liftgate jamb switch
- Left turn ind.
- Lock
- Malf. ind. lamp
- Nca
- Off
- Oil pressure ind.
- Park brake switch
- Pnk
- Power sliding door module (right quarter panel)
- Powertrain control module (right side of i/p)
- Right liftgate jamb switch
- Right turn ind.
- Run
- Service traction control
- Sliding door ind.
- Solid state
- Spares
- Speed- ometer
- Start
- Tan/
- Test or start
- Trac ctrl on
- Traction control lamp driver module (behind park brake bracket)
- Vehicle speed sensor buffer (right side of i/p)
- Volt- meter
- W/ 3.8l vin l only
- W/ daytime running lamps
- W/o daytime running lamps