INSTRUMENT CLUSTER – Mercury Mountaineer 2003 – SYSTEM WIRING DIAGRAMS

INSTRUMENT CLUSTER

Instrument Cluster Wiring Diagram for Mercury Mountaineer 2003

List of elements for Instrument Cluster Wiring Diagram for Mercury Mountaineer 2003:

• (in main harness, near breakout to central junction box) s206
• (w/ dual zone eatc)
• Air conditioning system
• Ambient air temperature sensor (w/ manual a/c) (right front of engine compt, near radiator support)
• Battery junction box (bjb) (left side of engine compt, at fender apron)
• C220a
• C220b
• C270e
• C270h
• Central junction box (cjb) (behind left side of dash)
• Charge ind
• Check engine ind
• Check gauge ind
• Computer data lines system
• Daytime running lamps (drl) module (left side of engine compt,on inner fender well)
• Defogger system
• Electronic compass
• Except base
• Except flex fuel
• Exterior lights system
• Flex fuel
• Fuel tank unit
• Fuse 15a
• Fuse 30a
• Fuse 5a
• G102 (left front of engine compt)
• G200 (at right "a" pillar)
• G300 (at left "a" pillar)
• G300 (left side "a" pillar)
• G400 (left rear of vehicle)
• Headlamps system
• High beam ind
• Hot at all times
• Hot in run or acc
• Hot in run or start
• Ignition switch
• Illumination (6 bulbs)
• Instrument cluster
• Interior lights system
• Joint connector 1 (in battery junction box)
• Key in ignition
• Left turn signal ind
• Message center switch
• Micro processor
• Nca
• Oil pressure switch (4.0l: left side of engine block) (4.6l: lower left side of engine block)
• Parking brake switch (under driver side dash panel)
• Power windows system
• Right turn signal ind
• S125
• S204
• S219
• S223
• S232
• Washer fluid level switch (right front of engine compt)