CRUISE CONTROL – Oldsmobile Silhouette 1994 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

3.1L

3.1L (VIN D), Cruise Control Wiring Diagram for Oldsmobile Silhouette 1994

List of elements for 3.1L (VIN D), Cruise Control Wiring Diagram for Oldsmobile Silhouette 1994:

• (engine compartment, mounted to left wheelhouse)
• (sps)
• (vents with brake
• 4000 pulses per mile output
• Brake in (vent/vac cntl)
• Closed
• Connected to throttle linkage
• Cruise control vacuum release valve/tcc switch
• Cruise control module (behind i/p, left of steering column)
• Cruise control servo
• Cruise control switch
• Cruise enable
• Fuse block
• G100 (engine compartment, mounted to left inner fender, near battery)
• G200 (lower left "a" pillar, left of park brake)
• Ground
• Hot in run
• Ign
• Ign fuse 15a
• Nca
• Off
• Pedal depressed) (mounted to brake pedal support)
• Pedal support)
• R/a
• Resume/accel input
• Sensor posit input (hi)
• Sensor posit input (lo)
• Servo position sensor
• Set
• Set/coast input
• Stoplamp/ cruise brake switch (opens with brake pedal depressed) (mounted to brake
• Tan
• Vacuum actuator
• Vacuum release port
• Vacuum source
• Vacuum valve
• Vacuum valve control
• Variable a/c signal
• Vehicle speed input
• Vehicle speed sensor (mounted to right top of transaxle)
• Vehicle speed sensor buffer (behind i/p compartment, above convenience center)
• Vent
• Vent valve
• Vent valve control
• Vss input

3.8L

3.8L (VIN L), Cruise Control Wiring Diagram for Oldsmobile Silhouette 1994

List of elements for 3.8L (VIN L), Cruise Control Wiring Diagram for Oldsmobile Silhouette 1994:

• (below right side of i/p, behind convenience center)
• (engine compartment, mounted to left wheelhouse)
• (sps)
• (vents with brake
• 5 volt ref
• Brk in (vent&vac cntls)
• C11
• C12
• C14
• Closed
• Connected to throttle linkage
• Convenience center
• Cruise control vacuum release valve/tcc switch
• Cruise control servo
• Cruise control switch
• Cruise control vacuum/tcc switch (mounted to brake
• Cruise on input
• Engine controls system (3.8l vinl) & a/c compressor controls system
• F11
• F16
• Fuse block
• G120 (right side of engine, below electronic ignition module)
• Hot in run
• Hot in run, bulb test, or start
• Ign fuse 15a
• Nca
• Off
• Pedal depressed) (mounted to brake pedal support)
• Pedal support)
• Pnk
• Powertrain control module (pcm)
• R/a
• Resume/accel input
• Sensor return
• Servo posit sens (hi)
• Servo posit sens (lo)
• Servo position sensor
• Set switch
• Set/coast input
• Stoplamp/ cruise brake switch (opens with brake pedal depressed) (mounted to brake
• Tan
• Throttle posit sens input
• Throttle position (tp) sensor (mounted to sequential fuel injection unit)
• Vac valve cntl
• Vacuum motor
• Vacuum release port
• Vacuum source
• Vacuum valve
• Variable a/c signal
• Vehicle speed sensor (mounted to top of transaxle)
• Vent
• Vent valve
• Vent valve cntl
• Vss input (hi)
• Vss input (lo)