WARNING SYSTEMS
Warning Systems Wiring Diagram for Suzuki Equator 2011
List of elements for Warning Systems Wiring Diagram for Suzuki Equator 2011:
- 15p
- 70j
- Air bag diagnosis sensor unit (below back of floor console)
- B16
- B69
- B7 (under left seat)
- Bat (f/l)
- Body control module (bcm) (right side of steering column under dash)
- Buckle sw lh
- Buzzer
- Can-h
- Can-l
- Combination meter
- Combination switch
- Computer data lines system
- Crew cab
- D216
- Door ind
- Door sw (dr)
- Fuse & fusible link box (left rear engine compt)
- Fuse 10a
- Fuse block (j/b) (under right side of dash)
- Fusible link g 50a
- Gnd
- Gnd (pwr)
- Hot at all times
- Hot in on or start
- Ign sw
- Input 1
- Input 2
- Input 3
- Input 4
- Input 5
- Key sw
- Key switch
- King cab
- Left front door switch
- Left seat belt buckle switch
- M18
- M19
- M20
- M28
- M35
- M40
- M40 61j
- M57 (above steering column)
- Output 1
- Output 2
- Output 3
- Output 4
- Output 5
- Pnk
- Pwr
- Red
- Remote keyless entry receiver (right side of dash)
- Seat belt ind
- Seat belt remind
- Sens gnd
- Signal
- Tire pressure ind
- Tire pressure warning check connector (under left side of dash)
- Tpms mode sw
- Unified meter control unit (w/ information display)