CRUISE CONTROL – Chevrolet Captiva Sport LT 2012 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Chevrolet Captiva Sport LT 2012

List of elements for Cruise Control Wiring Diagram for Chevrolet Captiva Sport LT 2012:

• (right kick panel)
• 5v ref
• Accelerator pedal position (app) sensor (on accelerator pedal linkage arm)
• All times
• App sen 1 sig
• App sen 2 sig
• Automatic transmission
• Automatic transmission input shaft speed (iss) sensor
• Automatic transmission output shaft speed (oss) sensor
• Body control module (bcm) (front of center floor console)
• Bpp sens sig
• Brake pedal position (bpp) sensor (on brake pedal mounting arm)
• Computer data lines system
• Control solenoid valve assembly
• Cruise ctrl ind
• Cruise ctrl sw sig
• Cruise ind
• Cruise switch
• Driver information center (dic) display
• Ecm fuse 15a
• Engine control module (ecm) (2.4l: left rear of engine compt) (3.0l: left front engine compt)
• G201
• Gmlan ser data bus+
• Gmlan ser data bus-
• Gmlan serial data
• Gnd
• Hot at
• Hot at all times
• I/p fuse block
• Ign 5volt
• Inflatable restraint steering wheel module coil
• Instrument panel cluster (ipc)
• Ipc fuse 10a
• Jx201
• Left steering wheel control switch
• Lo ref
• Logic
• Low ref
• Pnk
• Pnk (i/p harness, under center console) j202
• Reset+
• Set-
• Stop lamp sup volt
• Stop lamp sw sig
• Tac mot ctrl 1
• Tac mot ctrl 2
• Tan
• Throttle actuator control (tac) module (front top center of engine)
• Tp sen 1 sig
• Transmission control module
• Transmission control module (tcm) (near master cylinder)
• Transmissions system
• Underhood fuse block (left side of engine compt)
• X108
• X200