ELECTRONIC SUSPENSION – Chevrolet Venture LS 1998 – SYSTEM WIRING DIAGRAMS

ELECTRONIC SUSPENSION

Electronic Air Suspension Wiring Diagram, with Inflator for Chevrolet Venture LS 1998

List of elements for Electronic Air Suspension Wiring Diagram, with Inflator for Chevrolet Venture LS 1998:

• (lower left "d" pillar) g999
• Air compressor exhaust solenoid
• Air compressor motor
• Auto level control air compressor (under left rear of vehicle, behind wheelhouse)
• Auto level control air compressor relay
• Auto level control inflator relay (in left rear of vehicle, behind wheelhouse)
• Auto level control inflator solenoid valve (in left rear of vehicle, behind wheelhouse)
• Auto level control sensor (mounted to rear crossmember, above rear axle)
• Compressor signal
• Elc fuse 20a
• Exhaust signal
• Fuse block (right side of dash)
• G999 (lower left "d" pillar)
• Gnd
• Ground
• Hot at all times
• Hot in run, bulb test or start
• Ign 1 fuse 10a
• Inflation air switch (behind left rear wheelhouse)
• Nca
• Off
• Pnk
• Power input
• Reset
• Reset
• Resets after 10 minutes
• S337 (body harn, rear of left "b" pillar base)
• S441
• S443 (auto level control harn, under left rear wheelhouse)
• S445
• Solid state

Electronic Air Suspension Wiring Diagram, without Inflator for Chevrolet Venture LS 1998

List of elements for Electronic Air Suspension Wiring Diagram, without Inflator for Chevrolet Venture LS 1998:

• Air compressor exhaust solenoid
• Air compressor motor
• Auto level control air compressor (under left rear of vehicle, behind wheelhouse)
• Auto level control air compressor relay
• Auto level control sensor (mounted to rear crossmember, above rear axle)
• Compressor signal
• Elc fuse 20a
• Exhaust signal
• Fuse block (right side of dash)
• G999 (lower left "d" pillar)
• Ground
• Hot at all times
• Hot in run, bulb test or start
• Ign 1 fuse 10a
• Nca
• Pnk
• Power input
• Reset
• S337
• S441
• S445