WARNING SYSTEMS
Warning Systems Wiring Diagram for Chevrolet HHR LS 2008
List of elements for Warning Systems Wiring Diagram for Chevrolet HHR LS 2008:
- (in body harness, near center console, approximately 6 cm from breakout for g302) j307
- Acc
- Auto
- Battery
- Bcm 2 fuse 6 40a
- Body control module (bcm) (under center dash, below radio, on right side of center console)
- Brake ind
- Class 2 serial data
- Computer data lines system
- D12
- Driver belt buckle
- Driver belt switch
- E12
- Except panel van
- G201 (behind left end of dash)
- G203 (behind left end of dash)
- G301 (under driver's seat)
- G302 (under front) passenger's seat)
- Ground
- Head
- Hot at all times
- Ignition switch
- Inflatable restraint passenger air bag on/off indicator
- Inflatable restraint sensing & diagnostic module (sdm) (under center console, forward of park brake)
- Instrument panel cluster (ipc)
- J200
- J201
- J301
- J302
- Jx205 (in i/p harness, behind bcm taped to harness)
- Key in ignition switch
- Left front door jamb switch (left `a' pillar between door hinges)
- Left rear access panel latch (rear of left rear access panel)
- Left rear door jamb switch (center of left "b" pillar, between hinges)
- Left seat belt sw
- Lf door ajar sw sig
- Lo spd gmlan serial data
- Logic
- Low ref
- Low spd gmlan serial data
- Low spd serial data
- Lr door ajar sw sig
- Nca
- Off
- Off/run/crank volt
- Panel van
- Park
- Park brake sw sig
- Park brake switch (in center console, attached to emergency brake)
- Park lmp sw on sig
- Pass seat belt ind
- Passenger belt buckle
- Passenger belt switch
- Pnk
- Rf door ajar sw sig
- Right front door jamb switch (right `a' pillar between door hinges)
- Right rear access panel latch (rear of right rear access panel)
- Right rear door jamb switch (center of right "b" pillar, between hinges)
- Right seat belt sw
- Rr door ajar sw sig
- Run
- Seat belt ind
- Start
- Turn signal/ multi- function switch
- Underhood fuse block (in engine compt, next to left strut tower)