SHIFT INTERLOCK – Hummer H3T 2010 – SYSTEM WIRING DIAGRAMS

SHIFT INTERLOCK

Ignition Lock Solenoid Wiring Diagram for Hummer H3T 2010

List of elements for Ignition Lock Solenoid Wiring Diagram for Hummer H3T 2010:

• Automatic transmission shift lever
• Body control module (bcm) (behind right front kick panel)
• C12
• G106 (on right inner front wheelwell)
• Hot at all times
• Ignition lock cylinder control actuator (on upper right side of steering column)
• J143
• J205
• Park position switch (closed in park)
• Rap relay
• Rap/accy relay 88
• S/roof frt/wpr fuse 9 15a
• Underhood fuse block (above left front wheelwell)
• X200
• X201

Shift Interlock Wiring Diagram for Hummer H3T 2010

List of elements for Shift Interlock Wiring Diagram for Hummer H3T 2010:

• (in body harness, approximately 14 cm to right of stop lamp switch breakout in main harness)
• A31 x2
• A37
• A47 x1
• Automatic transmission
• Automatic transmission shift lever
• Automatic transmission shift lock control solenoid
• B+ voltage
• Bcm fuse 14 10a
• Body control module (bcm) (behind right front kick panel)
• Class 2 serial data
• Computer data lines system
• D1 x200
• Engine control module (ecm) (right rear corner of engine compt)
• Exterior lights system
• G102 (3.7l: on lower left side of engine block, rearward of g103) (5.3l:on engine block, below left cylinder head)
• G350 (suv: behind left rear quarter trim, near wheelwell) (truck: base of right "c" pillar)
• Ground distribution system
• Hot at all times
• J215
• J314
• P/n sig
• Park/ neutral position (pnp) switch
• Shift sol ctrl
• Stop fuse 50 15a
• Stop lamp control
• Stop lamp switch (above brake pedal assembly)
• Underhood fuse block (above left front wheelwell)
• X1 a7