SHIFT INTERLOCK – Jeep Commander 2008 – SYSTEM WIRING DIAGRAMS

SHIFT INTERLOCK

Shift Interlock Wiring Diagram for Jeep Commander 2008

List of elements for Shift Interlock Wiring Diagram for Jeep Commander 2008:

• (3.7l & 4.7l: right side of engine) (5.7l: right rear of engine) s141
• Autostick up/ down (ers) sens
• Autostick up/ down (ers) sens c3
• B15
• B16
• Brake sw 1 sig
• Brake sw 2 sig
• Brake sw sig
• Can c bas (+)
• Can c bas (-)
• Can c bus (+)
• Can c bus (-)
• Computer data lines system
• D64
• D65
• Electrohydraulic control unit assembly (on transmission)
• Except 3.7l
• Front control module
• Fuse 10a
• Fused ign sw
• Fused ign sw out (run-start)
• G100 (left rear of engine compt)
• G200
• Ground
• Hot in run or start
• Ignition wireless node
• Integrated power module (left side of engine compt)
• Interior lights system
• Ipm
• Junction block (left side of dash)
• K900
• P/n switch
• Panel lamp driver
• Powertrain control module (right rear of engine compt)
• S101
• S106
• S132 (except 3.7l)
• S134 (3.7l)
• S212
• Sens ground
• Shift lever assembly
• Stop lamp switch (lower left side of dash)
• T13
• T41
• T42
• T54
• Transmission control module (3.7l) (under left side of dash)
• Transmission solenoid/trs assembly (except 3.7l) (left side of transmission)
• Transmission temp sensor sig
• Transmission temperature sensor
• Trs park sig
• Trs t1 sense
• Trs t2 sense
• Trs t3 sense
• Trs t41 sense
• Trs t42 sense