CRUISE CONTROL – Ford Explorer 1996 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Ford Explorer 1996

List of elements for Cruise Control Wiring Diagram for Ford Explorer 1996:

• A/t w/ console
• A/t w/o console
• Accel
• Brake on/off (boo) switch (on brake pedal support)
• Brake on/off sw in
• Brake press input
• Brake pressure switch (left rear corner of engine compartment)
• C286
• Clock spring
• Clutch pedal position (cpp) switch (on clutch pedal arm)
• Clutch pedal position (cpp) switch jumper (left side of i/p, taped to main harness)
• Coast
• Fuse 15a
• Fuse 7.5a
• G100 (left front of engine compt. near radiator)
• G104 (left rear corner of engine compartment, at fender apron)
• Ground
• Horn switches
• Horn system
• Hot at all times
• Hot in run
• Ignition
• Ignition cylinder tamper switch
• Illumination
• Instrument cluster
• Instrument cluster system (headlamp switch, pin 8)
• Instrument cluster, body computer & electronic suspension systems
• Interior fuse panel
• Interior lights system
• M/t
• Nca
• Off
• Ohms
• Powertrain control module (pcm) (right rear of engine compartment)
• Resume
• Set/
• Speed cont lp out
• Speed cont sw gnd
• Speed cont sw in
• Speed control indicator
• Speed control servo/ amplifier assembly (right rear of engine compartment)
• Speed control/ horn switch assembly (in steering column assembly)
• Vehicle speed input
• Vehicle speed sensor (vss) (on transmission)
• Vss input