WARNING SYSTEMS – Nissan Murano S 2007 – SYSTEM WIRING DIAGRAMS

WARNING SYSTEMS

Warning Systems Wiring Diagram for Nissan Murano S 2007

List of elements for Warning Systems Wiring Diagram for Nissan Murano S 2007:

• 15a
• Air bag diagnosis sensor unit (below center console, between seats)
• B7 (behind left kick panel)
• Bat
• Batt
• Belt ind
• Body control module (behind left side of dash)
• Buzzer
• Can-h
• Can-l
• Comb sw in 1
• Comb sw in 2
• Comb sw in 3
• Comb sw in 4
• Comb sw in 5
• Comb sw out 1
• Comb sw out 2
• Comb sw out 3
• Comb sw out 4
• Comb sw out 5
• Combination meter
• Combination switch
• Computer data lines system
• Door ind
• Door sw (dr)
• Driver side front door lock assembly (door switch) (rear of left front door)
• Driver side front power seat
• Fuse & fusible link block (left front of engine compt, near battery)
• Fuse 10a
• Fuse block (j/b) (below left side of dash)
• Fusible link f 50a
• Gnd
• Gnd (power)
• Hot at all times
• Hot in on or start
• Ign
• Input 1
• Input 2
• Input 3
• Input 4
• Input 5
• Key sw
• Key switch & ignition knob switch (w/ intelligent key)
• Key switch (w/o intelligent key) (on right side of steering column)
• M14 (behind left end of dash)
• M34
• M35
• M36
• M49
• M50
• M64
• M78 (behind right end of dash)
• Output 1
• Output 2
• Output 3
• Output 4
• Output 5
• Red
• Rx (comb meter)
• Seat belt buckle switch
• Tx (comb meter)
• Unified meter & a/c amplifier (behind lower center of dash)
• Unified meter control unit