CRUISE CONTROL – Chevrolet Lumina 2001 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Chevrolet Lumina 2001

List of elements for Cruise Control Wiring Diagram for Chevrolet Lumina 2001:

• All times
• Cruise control module (front of left strut tower)
• Cruise control release switch (on brake pedal support)
• Cruise on/off
• Cruise release
• Cruise set/coast
• Cruise switch
• Disable input
• Disable output
• Engage ouput
• Engaged input
• Exterior lights system
• Fuse 10a
• Fuse 15a
• Fuse block (on right side of dash)
• G129 (on transaxle stud)
• Ground
• Hot at
• Hot in run, bulb
• Ignition
• Instrument cluster system
• Nca
• Off
• Pnk
• Powertrain control module (pcm) (right side of engine compt)
• R/a
• Resume/accel
• S105
• S116 (engine harness, at right strut tower)
• S205 (i/p harness, below center of dash)
• S247
• Set sw
• Stoplamp switch (on brake pedal support)
• Test or start
• Turn lever signal
• Vehicle speed input
• Vehicle speed out
• Vehicle speed sensor (vss) (right rear of engine compt, end of transaxle)
• Vss high
• Vss low