ENGINE PERFORMANCE – Subaru Legacy GT 1998 – SYSTEM WIRING DIAGRAMS

ENGINE PERFORMANCE

2.2L

2.2L, Engine Performance Wiring Diagrams (1 of 2) for Subaru Legacy GT 1998

List of elements for 2.2L, Engine Performance Wiring Diagrams (1 of 2) for Subaru Legacy GT 1998:

• (behind left side of dash) fuel pump relay
• (behind left side of dash) main relay
• (on top of fuel tank)
• (on top of fuel tank) fuel pump & fuel gauge module
• (under left side of dash) check connector
• A/c system
• B52
• Camshaft position sensor (on left of eng)
• Crankshaft position sensor (on lower center front of eng)
• Engine control module (under right sie of dash)
• F37
• F40
• Fuel gauge
• Fuel gauge sub module (awd) (on top of fuel tank)
• Fuel injectors
• Fuel tank pressure sensor
• Fuel temp gauge
• Fuse & relay box
• Fuse 10a
• Fuse 15a
• G115 (rear of eng)
• G202 (center of dash)
• G302 (below center console)
• Hot at all times
• Hot in run or start
• Ignition coil (on top center of eng)
• Ignitor (on center of firewall)
• Knock sensor (on top of eng, below throttle body assembly)
• Main fuse box
• Nca
• Oxygen sensor (front) (on front catalytic converter inlet)
• Oxygen sensor (rear) (on rear of catalytic converter)
• Red
• Sbf-2 30a
• Trans- missions control system

2.2L, Engine Performance Wiring Diagrams (2 of 2) for Subaru Legacy GT 1998

List of elements for 2.2L, Engine Performance Wiring Diagrams (2 of 2) for Subaru Legacy GT 1998:

• (2.5l) vent control solenoid valve (2.2l) drain valve
• (at right rear underside of vehicle)
• (part of air intake assembly, next to air cleaner box)
• (right front of engine compartment)
• (w/o anti-theft) (w/ anti-theft)
• A/c system
• A/t
• Acc
• Anti-lock brake system
• Boost sensor
• Cooling fan system
• Data link connector (right of steering column)
• Egr solenoid (on left side of eng)
• Engine control module (under right side of dash)
• Engine coolant temperature sensor (top right front of eng)
• G115 (rear of eng)
• G115 (rear of engine)
• G202 (center of dash)
• Hot at all times
• I10
• I11
• I12
• I14
• Idle air control solenoid valve (on top of eng, near throttle body assembly)
• Ignition switch
• Inhibitor switch
• Instrument cluster
• M/t
• Malfunction indicator lamp
• Mass air flow sensor
• Nca
• Neutral position switch (on left side of transmission)
• Obd-ii service connector (behind left side of dash)
• Off
• Pnk
• Pressure control solenoid valve (under rear of vehicle, near fuel tank)
• Pressure sources switching solenoid (on right side of eng compt)
• Purge control solenoid valve (on right side of eng)
• Red
• Shield joint connector (behind right kick panel)
• Speedo- meter circuit
• Start
• Starter interlock relay (left side of dash)
• Tacho- meter
• Test mode connector (behind dash, right of steering column)
• Throttle position sensor (on throttle body assembly)
• Transmissions control system
• Twisted wire
• Vehicle speed sensor 2 (on trans- mission)
• W/ tcs
• W/o tcs

2.5L

2.5L, Engine Performance Wiring Diagrams (1 of 2) for Subaru Legacy GT 1998

List of elements for 2.5L, Engine Performance Wiring Diagrams (1 of 2) for Subaru Legacy GT 1998:

• (behind left side of dash) fuel pump relay
• (behind left side of dash) main relay
• (on top of fuel tank)
• (on top of fuel tank) fuel pump & fuel gauge module
• (under left side of dash) check connector
• A/c system
• B52
• Camshaft position sensor (on left of eng)
• Crankshaft position sensor (on lower center front of eng)
• Engine control module (under right sie of dash)
• F37
• F40
• Fuel gauge
• Fuel gauge sub module (awd) (on top of fuel tank)
• Fuel injectors
• Fuel tank pressure sensor
• Fuel temp gauge
• Fuse & relay box
• Fuse 10a
• Fuse 15a
• G115 (rear of eng)
• G202 (center of dash)
• G302 (below center console)
• Hot at all times
• Hot in run or start
• Ignition coil (on top center of eng)
• Ignitor (on center of firewall)
• Knock sensor (on top of eng, below throttle body assembly)
• Main fuse box
• Nca
• Oxygen sensor (front) (on front catalytic converter inlet)
• Oxygen sensor (rear) (on rear of catalytic converter)
• Red
• Sbf-2 30a
• Trans- missions control system

2.5L, Engine Performance Wiring Diagrams (2 of 2) for Subaru Legacy GT 1998

List of elements for 2.5L, Engine Performance Wiring Diagrams (2 of 2) for Subaru Legacy GT 1998:

• (2.5l) vent control solenoid valve (2.2l) drain valve
• (at right rear underside of vehicle)
• (part of air intake assembly, next to air cleaner box)
• (right front of engine compartment)
• (w/o anti-theft) (w/ anti-theft)
• A/c system
• A/t
• Acc
• Anti-lock brake system
• Boost sensor
• Cooling fan system
• Data link connector (right of steering column)
• Egr solenoid (on left side of eng)
• Engine control module (under right side of dash)
• Engine coolant temperature sensor (top right front of eng)
• G115 (rear of eng)
• G115 (rear of engine)
• G202 (center of dash)
• Hot at all times
• I10
• I11
• I12
• I14
• Idle air control solenoid valve (on top of eng, near throttle body assembly)
• Ignition switch
• Inhibitor switch
• Instrument cluster
• M/t
• Malfunction indicator lamp
• Mass air flow sensor
• Nca
• Neutral position switch (on left side of transmission)
• Obd-ii service connector (behind left side of dash)
• Off
• Pnk
• Pressure control solenoid valve (under rear of vehicle, near fuel tank)
• Pressure sources switching solenoid (on right side of eng compt)
• Purge control solenoid valve (on right side of eng)
• Red
• Shield joint connector (behind right kick panel)
• Speedo- meter circuit
• Start
• Starter interlock relay (left side of dash)
• Tacho- meter
• Test mode connector (behind dash, right of steering column)
• Throttle position sensor (on throttle body assembly)
• Transmissions control system
• Twisted wire
• Vehicle speed sensor 2 (on trans- mission)
• W/ tcs
• W/o tcs