INSTRUMENT CLUSTER – Chevrolet Suburban K2500 1998 – SYSTEM WIRING DIAGRAMS

INSTRUMENT CLUSTER

5.7L

5.7L (VIN R), Instrument Cluster Wiring Diagram for Chevrolet Suburban K2500 1998

List of elements for 5.7L (VIN R), Instrument Cluster Wiring Diagram for Chevrolet Suburban K2500 1998:

• (6 bulbs)
• (taillamp extension harn, near fuel pump harness breakout)
• 5v ref
• A/t
• A/t 4wd
• Accy
• Air bag ind
• Anti- lock brakes ind
• Anti-lock brakes system
• Bat ind
• Brake ind
• Brake pressure warning switch (on rear of ebcm casting)
• Brake psi
• Bulb test
• Check gauges ind
• Check gauges lamp driver
• Daytime running lamps ind
• Daytime running lamps module (behind left side of dash, taped to dash harness)
• Electronic brake control module (on left side of engine compt)
• Engine controls system (fuel pump balance relay)
• Engine coolant temperature sender (left cylinder head)
• Exterior lights system
• Fuel
• Fuel gauge
• Fuel in
• Fuel pump & sender (in front fuel tank)
• Fuel pump & sender (in fuel tank)
• Fuel pump balance module (inside left side frame rail)
• Fuel pump/ oil pressure switch & sender (rear top center of engine)
• Fuel tank
• G119 (right front of engine block)
• G131 (near thermo- stat housing)
• G134 (front top of engine)
• Gauges fuse 4 10a
• Headlights system
• Hi beam ind
• Hot in run or start
• Hot in run, bulb test or start
• I/p fuse block (left end of dash)
• Ign
• Ign e mini fuse 10a
• Ign sw
• Ignition coil (right rear of engine)
• Ignition switch
• Illum
• Illumination
• Instrument cluster
• Interior lights system
• Led dimming
• Left turn ind
• Lock
• M/t
• M/t 4wd & all 2wd
• Mil ind
• Off
• Oil gauge
• Parity prndl
• Park brake warning switch (on park brake pedal bracket)
• Pk brake
• Pnk
• Prndl
• Prndl a
• Prndl b
• Prndl c
• Right turn ind
• Run
• S103
• S146
• S147
• S162
• S213
• S215
• S317
• S430
• Safety belt ind
• Secondary fuel gage sender (in rear fuel tank)
• Sens rtrn
• Service engine soon ind
• Single dual fuel tanks
• Speedo
• Speedometer
• Start
• Starting/charging system
• Tach
• Tan
• Temp gauge
• Trans fuse 20 10a
• Transmission range selector (left side of transmission)
• Twisted pair
• Underhood fuse- relay center
• Upshift ind
• Upshift ind (m/t only)
• Vehicle control module (left side of engine compt)
• Vehicle speed sensor (left rear of transmission or transfer case)
• Vehicle speed sensor (vss) adapter
• Voltmeter
• Vss
• Warning systems

6.5L

6.5L (VIN F), Instrument Cluster Wiring Diagram (1 of 2) for Chevrolet Suburban K2500 1998

List of elements for 6.5L (VIN F), Instrument Cluster Wiring Diagram (1 of 2) for Chevrolet Suburban K2500 1998:

• (6 bulbs)
• Air bag ind
• Anti- lock brakes ind
• Anti-lock brakes system
• Bat ind
• Brake ind
• Check gauges ind
• Check gauges lamp driver
• Daytime running lamps ind
• Engine controls system
• Engine coolant temperature sensor (on top right front of engine, near thermostat housing)
• Exterior lights system
• Fuel gauge
• G117 (top rear of right cylinder head)
• G119 (right front of engine block)
• G134 (front top of engine)
• G202 (behind left side of dash)
• Generator
• Gnd
• Headlights system
• Hi beam ind
• Ign
• Illum
• Illumination
• Instrument cluster
• Interior lights system
• Led dimming
• Left turn ind
• Low coolant ind
• Low coolant level indicator module (behind center of dash)
• Low coolant level sensor (in coolant reservoir, right side of engine compt)
• Oil press
• Oil pressure switch & sender (under intake manifold, center of engine)
• Parity prndl
• Pnk
• Prndl
• Prndl a
• Prndl b
• Prndl c
• Right turn ind
• S107
• S147
• S215
• S298
• Safety belt ind
• Service engine soon ind
• Service throttle soon ind
• Solid state
• Speed- ometer
• Starting/charging system
• Tach
• Tan
• Temp gauge
• Transmission range selector (left side of transmission)
• Up- shift ind (m/t)
• Volt- meter
• Wait to start ind
• Warning system
• Water in fuel ind
• Water-in fuel sensor (top rear of engine)

6.5L (VIN F), Instrument Cluster Wiring Diagram (2 of 2) for Chevrolet Suburban K2500 1998

List of elements for 6.5L (VIN F), Instrument Cluster Wiring Diagram (2 of 2) for Chevrolet Suburban K2500 1998:

• (engine harn, s157
• (i/p harn, 18 cm into cluster breakout)
• (i/p harn, 5 cm into power steering control module breakout)
• 20 cm into ebcm breakout)
• 4wd a/t
• 4wd m/t & all 2wd
• A/t
• Accy
• Anti-lock brakes system
• Brake ind
• Brake ind in
• Brake pressure warning switch (on rear of ebcm casting)
• Brake psi
• Bulb test
• C100
• Daytime running lamps module (behind left side of dash, taped to panel wiring harness)
• Diode 1
• Dual fuel tanks
• Electronic brake control module (left side of engine compt)
• Eng 1 mini fuse 20a
• Engine controls system
• Engine controls system (fuel pump balance relay)
• Fuel gage sender (in front fuel tank)
• Fuel pump & sender
• Fuel pump balance module (inside left side of frame rail)
• G119 (right front of engine block)
• G134 (front top of engine)
• Gauges fuse 4 10a
• Hot in run, bulb test or start
• I/p fuse block (left end of dash)
• Ign e mini fuse 10a
• Ign sw
• Ignition switch
• Lock
• M/t
• Off
• Park brake warning switch (on parking brake pedal bracket)
• Pk brake
• Pnk
• Radio
• Run
• S103
• S108
• S147
• S211
• S213
• S215
• S221
• S315
• S317
• Secondary fuel gage sender (in rear fuel tank)
• Single fuel tank
• Start
• Trans fuse 20 10a
• Transmission system
• Twisted pair
• Underhood fuse-relay center (left rear of engine compt)
• Vehicle speed sensor (left rear of transmission or transfer case)
• Vehicle speed sensor (vss) adapter
• Vehicle speed sensor buffer (behind right side of dash)