STARTING/CHARGING – Jeep Wrangler Islander 2010 – SYSTEM WIRING DIAGRAMS

STARTING/CHARGING

Charging Wiring Diagram for Jeep Wrangler Islander 2010

List of elements for Charging Wiring Diagram for Jeep Wrangler Islander 2010:

• A0 red
• A804
• B(+)
• Battery
• Can bus (+)
• Can bus (-)
• Cluster
• Computer data lines system
• Fusible link
• G100 (right side of engine compt)
• G101 (rear of engine)
• Gen field ctrl
• Gen sense
• Generator
• K125
• Powertrain control module (left side of engine compt)
• Red
• Starter
• Totally integrated power module (right side of engine compt)

Starting Wiring Diagram for Jeep Wrangler Islander 2010

List of elements for Starting Wiring Diagram for Jeep Wrangler Islander 2010:

• (left side of dash) g202
• (left side of engine compt) powertrain control module
• (or t41)
• A/t
• B(+)
• Battery
• C100
• C7 red
• Can bus(+)
• Can bus(-)
• Charging circuit
• Circuit board
• Clutch interlock sig (m/t) trs prk/ neu sig (a/t)
• Clutch interlock switch
• Clutch intlck sig
• Computer data lines system
• D64
• D65
• Fuse j17 40a
• Fuse m13 20a
• G100 (right side of engine compt)
• G101 (rear of engine)
• G103 (right side of engine compt)
• G202 (left side of dash)
• Gnd
• Hold-in
• Hot at all times
• Ign run st
• Ign run st sw snse
• Ignition switch
• Ignition wireless node
• Iod fd
• M/t
• Power distribution system
• Pull-in
• Red
• Run/ start relay
• S244
• S253
• Starter
• Starter relay
• Starter rly coil
• Starter rly coil rtn
• Starter rly ctrl
• T141
• T752
• Totally inte- grated power module (right side of engine compt)
• Trans rng prk/ neu sig
• Transmission range sensor (top of transmission)