CRUISE CONTROL – Saturn Ion Red Line 2004 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Saturn Ion Red Line 2004

List of elements for Cruise Control Wiring Diagram for Saturn Ion Red Line 2004:

• (2.0l)
• (2.2l)
• (early production)
• (in i/p harness, 6 cm from breakout for c235)
• (late production)
• 2.0l
• 2.0l 2.2l
• 2.2l
• 2.2l
• All times
• Body control module (bcm) (at lower center of dash)
• Clutch pedal position (cpp) switch (2.0l)
• Clutch/brake cruise fuse 7.5a
• Cpp sw sig
• Cruise control module (ccm) (behind lower left side of dash, above brake pedal)
• Ecm class 2 serial data
• Engine control module (ecm) (2.2l) powertrain control module (pcm) (2.0l) (2.2l: at left side of engine compt) (2.0l: at rear of engine, near coolant overflow container)
• Engine controls system
• Eps fuse 2a
• G203 (behind lower left side of dash, left of steering column)
• Ground
• Hot at
• Hot in acc or run
• Ign 1
• Inflatable restraint steering wheel module coil (behind steering wheel)
• Instrument cluster
• Ipc class 2 serial data
• Left steering wheel controls
• Logic
• Lower stop lamp switch (below left side of dash, attached to brake pedal bracket)
• Message center
• Off
• Pnk
• Resume/ accel
• Right steering wheel controls
• S227
• S233
• S239
• Servo clutch control
• Servo move control signal
• Servo move direction signal
• Set/ coast
• Set/coast resume/ accelerate signal
• Stop fuse 15a
• Stop lamp signal
• Tcc brake sw/cruise
• Underhood fuse block at left rear side of engine compt)
• Upper stop lamp switch (below left side of dash, attached to brake pedal bracket)
• Vehicle speed sensor (vss) (at rear of engine, on transaxle)
• Vss high
• Vss low