CRUISE CONTROL – Chevrolet Beretta Z26 1994 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Chevrolet Beretta Z26 1994

List of elements for Cruise Control Wiring Diagram for Chevrolet Beretta Z26 1994:

• #14
• (behind right side of inst.
• (behind upper right side
• (left rear of engine
• (left rear of engine on top of
• (lower right front of transaxle
• (on brake pedal
• (on clutch pedal support)
• (rear of engine compt
• (right rear of engine on transaxle)
• (right side of engine on top
• (vin 4)
• (vin 4/a/t)
• (vin a)
• (vin m & 4)
• (vin m)
• 15a
• 4000 pulses/mile
• A/t
• Alarm module
• Assembly
• Block
• Brake input
• Brake sw
• Center of dash panel)
• Compartment on trans.
• Compartment, above
• Cruise control clutch sw
• Cruise control module
• Cruise control servo
• Cruise engage output
• Cruise engaged input
• D13
• D14
• Engine control module (ecm)
• Fuse
• G101
• Ground
• Hot in accy or run
• Instrument cluster
• L4 vin 4 & a
• M/t
• Multi/function
• Multi/function lever
• Of inst. panel, attached
• Of transaxle)
• Off
• On input
• On output shaft housing)
• Panel, above glove box)
• Position
• R/a
• Red
• Resume/accel input
• Sensor
• Servo
• Servo postn input
• Set
• Set/coast input
• Starter)
• Stud)
• Support)
• Tan
• To a bracket)
• Transaxle)
• V6 vin m
• Vacuum valve
• Vacuum valve ctrl
• Vehicle speed sensor
• Vent valve
• Vent valve ctrl
• Vss input
• Vss input/hi
• Vss input/lo
• Wiper motor