CRUISE CONTROL – Chevrolet Corvette Z06 2004 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Chevrolet Corvette Z06 2004

List of elements for Cruise Control Wiring Diagram for Chevrolet Corvette Z06 2004:

• (on top of clutch pedal bracket) (m/t) clutch pedal position switch
• A11
• Accelerator pedal position (app) sensor (on top of accelerator pedal, part of mounting bracket)
• App 1 5v ref
• App 1 gnd
• App 1 sig
• App 2 5v ref
• App 2 gnd
• App 2 sig
• App 3 5v ref
• App 3 gnd
• App 3 sig
• Ccp sw sig
• Class 2 serial
• Computer data lines system
• Cr cont fuse 20 10a
• Cruise control switch
• Eng ign 1 fuse 19 10a
• Exterior lights system
• G106 (on right side of engine, above starter)
• Ground
• High front sig
• Hot at all times
• Hot in run or start
• Hot with ign relay energized (in run or start)
• I/p fuse block (in right front footwell, mounted to toe board)
• Ignition
• Instrument panel cluster (ipc)
• Low front sig
• Message display
• Multifunction turn signal lever
• Nca
• Off
• On/off sig
• Pnk
• Powertrain control module (pcm) (behind right front fender, between wheelhouse & dash panel)
• R/a
• Res/acc sig
• S120
• S213
• Serial data
• Set/ coast
• Set/coast sig
• Stop sw sig
• Stoplight switch (on top of brake pedal support) c2
• Stp haz fuse 8 20a
• Tac ctrl 1
• Tac ctrl 2
• Tac serl data
• Tan
• Tcc/cruise sw sig
• Throt cont fuse 17 15a
• Throttle actuator control (tac) module (on pcm, below battery)
• Throttle actuator control (tac) motor (on left side of throttle body)
• Throttle position (tp) sensor (on right side of throttle body assembly)
• Tps 1 5v ref
• Tps 1 gnd
• Tps 1 sig
• Tps 2 5v ref
• Tps 2 gnd
• Tps 2 sig
• Underhood fuse block (on right side of engine compt)
• Vehicle speed sensor (vss) (m/t: on right side of differential) (a/t: on top right side of differential)