CRUISE CONTROL – Chevrolet Uplander 2008 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Chevrolet Uplander 2008

List of elements for Cruise Control Wiring Diagram for Chevrolet Uplander 2008:

• (in steering column) inflatable restraint steering wheel module coil
• 10 volt ref
• 5 volt ref 1
• 5 volt ref 2
• Accelerator pedal position (app) sensor (on accelerator bracket)
• App sens 1 sig
• App sens 2 sig
• Body control module (bcm) (below left side of dash, left of steering column)
• Brake pedal position sensor (above brake pedal assembly)
• Brake sens sig
• Cancel
• Class 2 data
• Class 2 serial data
• Computer data lines system
• Cruise cancel
• Cruise control switch
• Cruise ctrl sw sig stop lamp volt
• Cruise ind
• Cruise/ switch fuse 9 2a
• Engine control module (ecm) (in air cleaner assembly)
• Gmlan hi spd (+)
• Gmlan hi spd (-)
• Hot w/ ign main relay energized
• I/p fuse block (right side of dash, behind access panel)
• Instrument panel cluster (ipc)
• J202 (in dash harness, 10.5 cm from breakout for x204 toward g200)
• Logic
• Low ref
• Nca
• Pnk
• Radio
• Rear object sensor control module (behind right rear interior body panel)
• Res+
• Set-
• Stop lamp sply
• Tac motor ctrl 1
• Tac motor ctrl 2
• Tan
• Throttle actuator control (tac) module (rear of engine, on throttle body assembly)
• Tp sens 1 sig
• Tp sens 2 sig
• Transmission control module (behind coolant reservoir)
• Underhood fuse block (in underhood compt, above right front wheel well)
• Vehicle speed sensor (vss) (lower right rear of underhood compt, mounted to right side of transmission)
• Vss
• Vss high sig
• Vss low sig
• W/ traffic information receiver
• W/o traffic information receiver
• X277
• X279