CRUISE CONTROL – Toyota Sequoia SR5 2001 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Toyota Sequoia SR5 2001

List of elements for Cruise Control Wiring Diagram for Toyota Sequoia SR5 2001:

• (2wd)
• (4wd)
• +b1
• +bm
• 4wd control ecu (behind right center of dash)
• A12
• Accel position sensor (on throttle body)
• Batt
• C/c
• Cancel
• Ccs
• Cl+
• Cl-
• Combination meter
• Cruise
• Cruise control switch (combination switch)
• D position switch (park/neutral position switch) (on trans)
• D10
• D12
• E01
• E02
• E03
• E10
• E17
• Ecc
• Ects fuse 15a
• Efi 1 fuse 20a
• Efi relay
• Engine control module (behind right side of dash)
• Engine room j/b (on left side of engine compt)
• F11
• G104 (on left side of engine compt)
• G112 (left side of engine)
• G117 (right rear of engine)
• Gauge fuse 10a
• Ge01
• Hot at all times
• Hot in run or start
• I4 (i/p harn, behind right side of dash)
• Ign1 fuse 10a
• Igsw
• Instrument panel j/b (behind left end of dash)
• Ipo
• J/c 15
• J/c 16 (behind right end of dash)
• Me01
• Mrel
• Pnk
• Res/ acc
• Set/ coast
• Spd
• St1-
• Stop fuse 15a
• Stoplight switch (on bracket, above brake pedal)
• Stp
• Sub j/b 3 (behind right side of instrument cluster)
• Sub j/b 4 (behind right side of instrument cluster)
• Throttle control motor (on throttle body)
• Throttle position sensor (on throttle body)
• Vehicle speed sensor (combination meter)
• Vpa
• Vpa2
• Vta
• Vta2