NAVIGATION – Cadillac XLR V 2006 – SYSTEM WIRING DIAGRAMS

NAVIGATION

Parking Assistant Wiring Diagram for Cadillac XLR V 2006

List of elements for Parking Assistant Wiring Diagram for Cadillac XLR V 2006:

• Backup lamp sply voltage
• Body control module (bcm) (behind right side of dash)
• Center amber ind
• Center amber ind ctrl
• Engine control module (ecm) (behind lower right front fender)
• G302
• Ground
• Hot at all times
• Ign 1 voltage
• Instrument cluster system
• Left amber ind
• Left amber ind ctrl
• Left rear corner object sensor (left corner of rear bumper)
• Left rear middle object sensor (left middle of rear bumper)
• Logic
• Lr corner object sens sig
• Lr middle object sens sig
• Object sens low ref
• Object sens sply voltage
• Pnk
• Power distribution system
• Rear object sensor control module (behind rear compartment stowage trim panel)
• Rear parking assist (rpa) diagnostic connector
• Rear parking assist (rpa) display
• Rear parking assist chime sig
• Rear parking diagnostic sig
• Red ind
• Red ind crtl
• Reverse lamp relay 3
• Reverse lamp rly ctrl
• Reverse lamps fuse 21 10a
• Right rear corner object sensor (right corner of rear bumper)
• Right rear middle object sensor (right middle of rear bumper)
• Rpa/ h/c seat fuse 11 10a
• Rr corner object sens sig
• Rr middle object sens sig
• Run/ crank relay 2
• Run/crank rly ctrl
• S211 (left side ignition control module jumper, approximately 5.0 cm from breakout for connector c109)
• S479
• S480
• Spice pack sp302 (in instrument panel harness, on right "b" pillar behind trim panel, grounded to g302 (ckt 750))
• Telltale assembly sply voltage
• Underhood fuse block (right rear of engine compt)
• Vehicle speed sig
• Vehicle speed sig c1