ELECTRONIC SUSPENSION – Hummer H2 2008 – SYSTEM WIRING DIAGRAMS

ELECTRONIC SUSPENSION

Electronic Suspension Wiring Diagram for Hummer H2 2008

List of elements for Electronic Suspension Wiring Diagram for Hummer H2 2008:

• 5v ref
• Active ind ctrl
• Air susp relay
• Air susp sig
• Air suspension control module (center rear of vehicle, in front of trailer hitch)
• Air suspension relay (mounted on left fender behind the battery)
• Auto level ctrl
• Body control module (bcm) (on lower left side of i/p to the left of steering column)
• Comp 1 sig
• Computer data lines system
• Coone
• Cotwo
• Ecas fuse 32 15a
• Ecas fuse 51 60a
• Ecas rly ctrl
• G401 (at left rear frame body mount)
• G405 (at right rear frame body mount)
• Gnd
• Hi spd bus+
• Hi spd bus-
• Hot at all times
• Hs-gnd
• Inflator air switch (right rear corner of cargo bed)
• Inflator sw
• Inflator sw sig
• Info not available
• J360 (in chassis harness, 10 cm from fuel pump flow control module main harness breakout)
• Left rear air suspension sensor (at left rear frame rail, attached to top of frame)
• Low ref
• Lr susp sig
• Nca
• Overtemp sig
• P-t
• Ride height sw
• Right rear air suspension sensor (at right rear frame rail, attached to top of frame)
• Rr susp sens
• S-four
• S-three
• S-two
• Serial data
• Tan
• Underhood fuse block (at left side of engine compt, near battery)