STARTING/CHARGING – Hummer H2 2008 – SYSTEM WIRING DIAGRAMS

STARTING/CHARGING

Charging Wiring Diagram for Hummer H2 2008

List of elements for Charging Wiring Diagram for Hummer H2 2008:

• 200a
• Aux hvac ign fuse 41 10a
• Battery
• Battery cable junction block (part of positive battery cable assembly)
• Body control module (bcm) (on lower left side of i/p to the left of steering column)
• Bus+
• Bus-
• Charge ind
• Chg ind
• Computer data lines system
• Driver information center (dic)
• Engine control module (ecm) (left front of engine compt below battery & fuse block underhood)
• G100 (on left front frame body mount)
• G102 (at left front side of engine block)
• G103 (on front of right cylinder head)
• Gen sig
• Generator
• Gmlan
• Gnd
• Hot at all times
• Hot w/ run/ crank relay energized
• Instrument panel cluster (ipc)
• Ipc fuse 10a
• Logic
• Low ref
• Mega fuse
• Pnk
• Power distribution system
• Red
• Sens sig
• Starter
• Tan
• Underhood fuse block (at left side of engine compt, near battery)
• Volt

Starting Wiring Diagram for Hummer H2 2008

List of elements for Starting Wiring Diagram for Hummer H2 2008:

• 5-volt reference
• Automatic transmission
• Battery
• Battery cable junction block (part of positive battery cable assembly)
• Body control module (bcm) (on lower left side of i/p to the left of steering column)
• Computer data lines system
• Control solenoid valve assembly
• Data bus+
• Data bus-
• Engine control module (ecm) (left front of engine compt below battery and fuse block underhood)
• G100 (on left front frame body mount)
• G102 (at left front side of engine block)
• G104 (at rear of left cylinder head)
• Ignition iii voltage
• Ignition switch
• Internal mode switch (ims)
• J102
• Off
• P/n
• Park/ neutral signal
• Red
• Run acc
• Start
• Starter
• Starter enable relay ctrl
• Strtr fuse 54 40a
• Strtr relay
• Tan
• Underhood fuse block (at left side of engine compt, near battery)
• X2 f1