CRUISE CONTROL
Cruise Control Wiring Diagram for GMC Savana G2500 2012
List of elements for Cruise Control Wiring Diagram for GMC Savana G2500 2012:
- (6 speed a/t)
- (or pnk)
- 12v ref
- 4.3l
- 4.8l, 5.3l & 6.0l
- 5v ref
- 5v ref 1
- 5v ref 2
- 6.6l
- A13
- A17
- Accelerator pedal position (app) sensor (under left side of dash)
- App sen 1 sig
- App sen 2 sig
- Automatic transmission
- Automatic transmission output shaft speed (oss) sensor
- Automatic transmission output shaft speed (oss) sensor assembly
- Batt +
- Bcm 2 fuse 58 15a
- Body control module (bcm) (behind lower right side of dash)
- Brake low ref
- Brake pedal position (bpp) sensor (top of brake pedal assembly)
- Brake sens sig
- Cancel
- Computer data lines system
- Control solenoid valve assembly
- Cruise control ind dimming sig
- Cruise control switch signal
- Cruise ind
- Cruise switch
- Data bus +
- Data bus -
- Ecm batt fuse 19 10a
- Engine control module (ecm)
- Fuel tem sig
- G103 (4.3l: left rear of engine) (4.8l, 5.3l & 6.0l: on right rear of engine)
- G109
- G302 (behind left kick panel)
- Gmlan
- Ground
- Hi spd gmlan ser data bus(+)
- Hi spd gmlan ser data bus(-)
- Hot at all times
- Hot w/ run/crank relay 15 energized
- Ign
- Inflatable restraint steering wheel module coil (at top of steering column)
- Instrument panel cluster (ipc)
- Ipc fuse 10 10a
- J101
- J127
- J160
- J209 (in steering wheel harness, near x200 connector)
- J244
- J248
- Left steering wheel control switch
- Logic
- Low ref
- Pnk
- Red
- Res+
- Ser data bus(+)
- Ser data bus(-)
- Set-
- Sound systems
- Tac motor ctrl 1
- Tac motor ctrl 2
- Tan
- Throttle body (except 6.6l)
- Tp sens 1 sig
- Tp sens 2 sig
- Trans- missions system
- Transmission control module (4 speed a/t) (6.6l: left front corner of engine compt)
- Transmission control module (tcm)
- Underhood fuse block (on left side of engine compt)
- Vss high sig
- Vss low sig
- W/ radio redundant steering wheel control
- W/o radio redundant steering wheel control
- X100
- X103
- X107
- X200