CRUISE CONTROL – Cadillac XLR 2008 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

4.4L VIN D

4.4L VIN D, Cruise Control Wiring Diagram for Cadillac XLR 2008

List of elements for 4.4L VIN D, Cruise Control Wiring Diagram for Cadillac XLR 2008:

• (behind lower left side of dash) brake pedal position sensor
• (passenger seat, behind rear compt stowage trim panel) objective alarm module
• (right side of engine compt, under battery) g104
• 5 volt ref
• 5-volt ref-1
• 5-volt ref-2
• A iss signal
• A15
• Acceleration pedal position (app) sensor (top of accelerator pedal assembly)
• App sen 1 sig
• App sen 2 sig
• Automatic transmission
• Automatic transmission input shaft speed (iss) sensor
• Automatic transmission output shaft speed (oss) sensor
• B batt + vol
• Batt5 fuse 5 30a
• Battery positive voltage
• Body control module (bcm) (behind right right side of dash)
• Brake pedal position switch signal
• C oss signal
• Computer data lines system
• Cruise control switch
• Cruise ctrl set/coast & resume/ accel sw signal
• D12
• Data bus +
• Data bus -
• Engine control module (ecm) (lower right rear of engine compt)
• Ground
• Heads up display (hud) (top left side of dash)
• High speed gmlan serial data bus +
• High speed gmlan serial data bus -
• Hot at all times
• Hud message center
• Instrument panel cluster (ipc)
• J211 (in instrument panel harness, approximately 25 cm from park brake pedal assembly breakout)
• J232
• J276 (in instrument panel harness, approximately 14.5 cm from breakout to automatic transmission shift lever)
• Logic
• Low ref
• Low reference
• Message request
• Nca
• Off
• Radio
• Red
• Resume/ accel +
• Serial data bus +
• Serial data bus -
• Set/coast
• Stop lamp sw sig
• Stop lamp switch signal
• Switch signal
• Tac motor ctrl-1
• Tac motor ctrl-2
• Tan
• Throttle actuator control (tac) motor
• Throttle body assembly (top of engine, at intake manifold)
• Throttle position (tp) sensor
• Tp sen 1 sig
• Tp sen 2 sig
• Transmission control module
• Turn signal/ multifunction switch
• Underhood fuse block (right rear of engine compt)
• Vehicle speed sig
• Vehicle speed signal
• Vehicle speed signal hud class 2 serial data

4.6L VIN A

4.6L VIN A, Cruise Control Wiring Diagram for Cadillac XLR 2008

List of elements for 4.6L VIN A, Cruise Control Wiring Diagram for Cadillac XLR 2008:

• (behind lower left side of dash) brake pedal position sensor
• (in instrument panel harness, approxi- mately 25 cm from park brake pedal assembly breakout) j211
• (passenger seat, behind rear compt stowage trim panel) objective alarm module
• 5 volt ref
• 5-volt ref 2
• Acc gap adjust switch signal
• Acc/ tcm fuse 3 10a
• Acca/driv dr sw fuse 21 10a
• Automatic transmission
• Automatic transmission input shaft speed (iss) sensor
• Automatic transmission output shaft speed (oss) sensor
• Batt
• Batt positive volt
• Bcm high speed gmlan serial data bus +
• Bcm high speed gmlan serial data bus -
• Body control module (bcm) (behind right side of dash)
• Brake pedal position switch signal
• C10
• Can bus +
• Can bus -
• Computer data lines system
• Cruise control forward vehicle distance sensor
• Cruise control switch
• Cruise ctrl set/coast & resume/ accel sw signal
• Distance sensing cruise control (dscc) module (center front of engine compt)
• Driver information center (dic)
• E11
• Engine control module (ecm) (lower right rear of engine compt)
• G102
• G302
• Gnd
• Ground
• Heads up display (hud) (top left side of dash)
• Hot at all times
• Hot w/ run/crank relay 7 energized
• Hud class 2 serial data
• Hud message center
• Ign 1
• Ign 1 volt
• Inflatable restraint steering wheel module coil (in steering wheel)
• Instrument panel cluster (ipc)
• J240
• Jx102 (in forward lamp harness, in engine compt, on upper right frame rail, grounded to g102)
• Jx302 (in instrument panel harness, on right "b" pillar behind trim panel, grounded to g302)
• Left steering wheel control switch
• Logic
• Low ref
• Message request
• Nca
• Off
• Pnk
• Power distribution system
• Radio
• Red
• Resume/ accel +
• Run/ crank relay 7
• Run/ crank rly ctrl
• Serial data bus +
• Serial data bus -
• Set/coast
• Stop lamp sw sig
• Stop lamp switch signal
• Tac motor ctrl-1
• Tac motor ctrl-2
• Tan
• Throttle actuator control (tac) motor
• Throttle body assembly (top of engine, at intake manifold)
• Throttle position (tp) sensor
• Tp sens 1 sig
• Tp sens 2 sig
• Transmission control module (tcm)
• Turn signal/ multifunction switch
• Tutd sw/ strg col sw fuse 28 2a
• Underhood fuse block (right rear of engine compt)
• Vehicle speed sig
• Vehicle speed signal
• X1 a15
• X5 k