CRUISE CONTROL – Chrysler PT Cruiser Touring 2006 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Chrysler PT Cruiser Touring 2006

List of elements for Cruise Control Wiring Diagram for Chrysler PT Cruiser Touring 2006:

• (a/t)
• (m/t)
• (near breakout for camshaft position sensor)
• A931
• C11
• Clutch interlock switch (m/t) (left side of dash)
• D15
• D16
• D20
• D21
• Data link connector (under left side of dash, near kick panel)
• Dump
• F855
• Fuse 10a
• Fused b(+)
• G105 (left front inner fender)
• Hot at all times
• Input speed sens sig
• Input speed sensor (a/t) (on left side of transaxle)
• Interlock switch sig
• K75
• K914
• Output speed sens sig
• Output speed sensor (a/t) (on left side of transaxle)
• Powertrain control module (on firewall, behind power distribution center)
• Red
• S/c sw 1 sig
• S/c sw rtn
• S109
• S128 (right front of engine compartment)
• Sci receive
• Sci receive (tcm)
• Sci transmit
• Sci transmit (tcm)
• Sensor gnd
• Sensor ground
• Sensor sig
• Speed control servo (2.4l) (at right rear corner of engine compt)
• Speed control switch
• Speed sig
• Speed signal
• Speed sw sig
• Steering control module (left side of dash)
• Stop lamp switch (left side of dash)
• T14
• T141
• T41
• T52
• Totally integrated power module
• Transmission range sensor (a/t) (in transaxle, on top of valve body)
• Trs t41 sns
• V32
• V35
• V36
• V71
• Vacuum
• Vacuum sol
• Vehicle speed sensor (m/t) (on transaxle)
• Vent
• Vent sol