POWER DISTRIBUTION – Dodge Caliber SXT 2010 – SYSTEM WIRING DIAGRAMS

POWER DISTRIBUTION

Power Distribution Wiring Diagram (1 of 3) for Dodge Caliber SXT 2010

List of elements for Power Distribution Wiring Diagram (1 of 3) for Dodge Caliber SXT 2010:

• (above right rear wheelwell) s328
• (left of instrument panel) s203
• (left side of body, below "b" pillar) s329
• (left side of engine compt, under fuse/relay block) s024
• (not used)
• B(+)
• Battery
• Bus bar
• C103
• C105
• C11
• C201
• C202
• C203
• C301
• C305
• C323
• Circuit board
• Cluster
• Data link connector
• Fuse 10a
• Fuse 15a
• Fuse 19 20a
• Fuse 20a
• Fuse 25a
• Fuse 30a
• Fuse 40a
• Fuse/relay block (left front corner of engine compt)
• Generator
• Hands free module
• Hvac a/c heater control
• Left multi-fuction switch
• Left turn trailer tow relay
• Lower bank switch
• Main relay
• Mirror switch
• Powertrain control module
• Radio amplifier
• Red
• Right turn trailer tow relay
• S101
• S150 (left front of engine)
• S201
• S318
• S365
• Starter
• Stop lamp switch
• Subwoofer speaker (if equipped)
• Sunroof motor (if equipped)
• To ignition wireless node (daigram 2 of 3)
• Totally integrated power module (left side of engine compt)
• Trailer tow park lamp relay
• Ugdo module

Power Distribution Wiring Diagram (2 of 3) for Dodge Caliber SXT 2010

List of elements for Power Distribution Wiring Diagram (2 of 3) for Dodge Caliber SXT 2010:

• (body harness, near left side instrument panel) s305
• (left side of body, below "b" pillar) s320
• (not used)
• (run-acc) ign sw out fused
• 110 volt ac commom
• A999
• Ac commom 110 volt
• Ac line 1 110 volt
• Ac power outlet
• Batt feed
• Bus bar
• C103
• C200
• C201
• C202
• C203
• C204
• C310
• Can bus (+)
• Can bus (-)
• Circuit board
• Cluster
• Computer data lines system
• Console) s200
• Cvt
• Enb sw sig inverter
• From splice s201 (diagram 1 of 3)
• Fuse 10a
• Fuse 15a
• Fuse 20a
• Fuse 30a
• Fused b(+)
• Fused ign sw out (run-acc)
• G200 (2.ol) (near left "a" pillar)
• G200 (near left "a" pillar)
• G250
• G250 (2.4l)
• Gnd
• Ground
• Ign sw out (run-start)
• Ign sw sense
• Ignition switch
• Ignition wireless node
• Instrument panel power outlet
• Inverter enb sw sig
• Inverter module (behind lower center of dash)
• Left front tire pressure transponder
• Left rear tire pressure transponder
• Lin tire press
• M/t
• P801
• P805
• P809
• Radio
• Rear dome lamp
• Rear wiper motor
• Red/ pnk
• Right rear tire pressure transponder
• S210 (left of instrument panel)
• S217 (2.ol)
• S220 (left side of instrument panel)
• S310 (behind left kick panel)
• Sunroof motor
• Totally integrated power module (left side of engine compt)
• Transmission control module
• W/ sunroof
• Z908

Power Distribution Wiring Diagram (3 of 3) for Dodge Caliber SXT 2010

List of elements for Power Distribution Wiring Diagram (3 of 3) for Dodge Caliber SXT 2010:

• (center front of engine compt, above left radiator fan) s003
• (left of instrument panel) s208
• (left of instrument panel) s209
• (not used)
• Anti-lock brakes module
• Bus bar
• C103
• C11
• C200
• C202
• C203
• C302
• C303
• C305
• Circuit board
• Cluster
• Compass
• Compass module
• Driver window/ door lock switch
• Except compass
• Fuse 10a
• Fuse 30a
• Fuse 40a
• Fused ign sw out (run)
• Fused ign sw out (run-start)
• Heated seats module (if equipped)
• Hvac a/c heater control
• Ign sw out (run-acc)
• Ign sw out (start)
• Ign sw out (unlock run- start)
• Infrared sensor
• Inside rearview mirror
• Left front tire pressure transponder
• Left multi-function switch
• Left rear tire pressure transponder
• Occupant restraint controller (orc) module
• Passenger window/ door lock switch
• Pnk/ red
• Powertrain control module
• Right rear tire pressure transponder
• S375
• Stop lamp switch
• Totally integrated power module (left side of engine compt)
• Transmission range sensor (cvt)