CRUISE CONTROL – Nissan Pathfinder SE 2008 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Nissan Pathfinder SE 2008

List of elements for Cruise Control Wiring Diagram for Nissan Pathfinder SE 2008:

• 1q e160
• 8p m4
• Accel/ resume switch
• Accelerator pedal position sensor
• Aps1
• Aps2
• Ascd brake switch (on bracket, above brake pedal)
• Ascd steering switch
• Ascd sw
• Avcc
• Avcc 2
• Avcc2
• Bncsw
• Brake
• Can-h
• Can-l
• Cancel switch
• Close
• Coast/ set switch
• Combination meter
• Combination switch (spiral cable)
• Computer data lines system
• Cruise ind
• E16
• E24 (right front of engine compt)
• Ecm (right rear of engine compt)
• Electric throttle control actuator (near throttle body)
• F54
• Fuse 12 10a
• Fuse 14 10a
• Fuse 19 10a
• Fuse 20 10a
• Fuse block (j/b) (behind right side of dash)
• Gnd-a
• Gnd-a2
• Ground
• Hot at all times
• Hot in on or start
• M102
• M30
• M61 (behind right side of dash)
• Motor 1
• Motor 2
• Nca
• On/off main switch
• Open
• Pnk
• Red
• Sensor 1
• Sensor 2
• Set ind
• Stop lamp switch (on bracket, above brake pedal)
• Tps 1
• Tps 2
• Unified meter control unit