SUPPLEMENTAL RESTRAINTS
Supplemental Restraint Wiring Diagram for Chevrolet Beretta 1995
List of elements for Supplemental Restraint Wiring Diagram for Chevrolet Beretta 1995:
- A10
- A11
- A12
- Airbag in-line fuse 3a
- Arming sens feed
- Arming sens sig
- Arming sensor (right upper i/p, attatched to underside of upper dash panel)
- B10
- B11
- B12
- Diagnostic energy reserve module (derm) (behind right front kick panel)
- Dlc
- Forward discriminating sensor (attached to radiator support)
- Fuse 3 10a
- Fuse 9 20a
- Fuse block (left side of i/p)
- G104 (left rear of engine compt)
- Hot in run, bulb test or start
- Hot in start when in p/n (a/t) or when clutch fully depressed (m/t)
- Ign fuse output
- Ign output
- Ind lp output
- Inflatable restraint ind
- Inflator feed
- Inflator module
- Inflator output
- Instrument cluster
- M data link conn (left lower hush panel)
- Nca
- Passenger compt discriminating sensor (under center console)
- Pnk
- Seat belt sw
- Shorting bar
- Sir coil assembly
- Sir gnd
- Start input
- Tan
- Warning system (seat belt switch)