DescriptionThe side lights are switched on when the ring nut on the steeringcolumn is turned to the first position, with the ignition in theON position.They can also be turned on by extractingthe key and turning it in the opposite direction - PARK position- keeping the special button pressed.Turning on the side lights also turns onthe number plate lights and numerous other interior lights for passengercompartment lighting and instrument & control lighting (theselines are described and illustrated in the diagrams for the componentsto which they refer).The circuit is protected by two fuses, onefor the right-hand lights, one for the left-hand lights.A warning light in the panel (rev countermodule) indicates that the side lights have been switched on.The correct operation of the side lightsand the number plate lights is controlled by the check device forthe exterior lights located inside the rev counter module.The following faults may occur:blown bulbbulb s.c. to earth or positiveA special failure warning light, also inthe rev counter module, comes on for all other faults in the variouscircuits. This warning light comes on for about 4 seconds when theignition key is turned to MAR, to indicate it is working properly,then it goes off.
Functional description The signal for activating the side lights is sent to pin 3 ofconnector A of the rev counter E15 from switch H1 (POS). This signal reaches the ignition switch H1 (STAZ)from the supply controlled by the ignition (INT) for the line protectedby fuse B11 up to 2/99 or fuse F4 of the additionalfuse box B98B from 2/99. Alternatively - with the key in the PARKposition - the supply arrives directly from the battery (maxifuseIGN of B5 ) up to 2/99 or of B99 from 2/99. The supply for the check device inside E15arrives directly from the battery. (maxifuse J/B2 of B5 up to 2/99 or of B99 from 2/99) to pins 10 and 16 of connectorA, through fuses F2 and F3 of the junction unit B1 ; The former protects the left light circuits, the second protectsthe right light circuit. The check device therefore controls thesupply of the front side lights F10 (left) and F11 (right),the rear side lights F30 (left) and F31 (right) andthe number plate lights F50 and F51 . At the same time, the "side lightson" warning light - inside E15 - is also switched onwith pin 14 of connector A providing the earth. In the case of failures in the circuit,the "lights failure" warning light - inside E15 -comes on, with the supply controlled by the ignition (INT) for theline protected by fuse B11 up to 2/99 or fuse F4 ofthe additional fuse box B98B from 2/99, pin 15 of connectorA. The signal for activating the side lightsis also sent to the speedometer module E10 (pin 5, connectorB).( 3234310SeeE4021SPEEDOMETER )
<anchor>0</anchor><span>Removing</span><icon><imageid>20</imageid></icon>1Refitting21Place the car on a ramp.Undo the bolt securing the bracket on thebattery mount.Release the battery from the anchoragebracket complete with strap and remove.
5530B14
769768768
5530B18
Follow these precautions.769On batteries with an opticam hydrometer,electrolyte level and battery charge status can be monitored qualitativelyby examining the indicator colour:a light, bright colour indicates low electrolytelevel: top up with distilled water;a dark colour without a green area in thecentre indicates that the electrolyte level is correct but chargeis low: recharge the battery;a dark colour with a green area in themiddle indicates that both electrolyte level and charge status arecorrect: no action is necessary. For more details 3238420See subassembly5530 CURRENT GENERATOR . 768Proceed as follows.Check the battery voltage without loadusing the test device recommended by the Service outlets (e.g. 'MICRO360').Depending on the voltage values measured,which define the state of charge of the battery, proceed as follows: If the voltage without load is less than12.10 V, replace the battery ( 32384295530B10battery - r+r ). If the voltage without load is over 12.10V but less than 12.50 V, recharge the battery ( 32384305530B14battery - recharge ). If the voltage without load is over 12.50V, the battery is efficient.If necessary, top up the electrolyte asfollows.Carefully remove the cap strip.Top up with distilled and deionized water,taking care not to allow electrolyte to splash out.768
5530B22
<anchor>0</anchor><span>Removing</span><icon><imageid>20</imageid></icon>1Refitting21Place the car on the liftingbridge.1. Open engine compartment cap and disconnect battery negative terminal.2. Disconnect mass terminal on side member.3. Lift the car and disconnect mass terminal on gearbox.4. Lower the car again and remove battery earth lead.2018767
<anchor>0</anchor><span>Removing</span><icon><imageid>20</imageid></icon>1Refitting21Disconnect the battery negative terminal.1. Open the protective cover2. Loosen the nut and disconnect the ABS supply lead3. Loosen the nut and disconnect the starter motor supply lead4. Undo the clip and undo the box retaining bolts.5. Loosen the battery positive terminal nut.2018769
5530B52
<anchor>0</anchor><span>Removing</span><icon><imageid>20</imageid></icon>1Refitting213238429-5530B10battery - r+rRelease the air duct hose from the mountingbracket on the drip tray. Remove the relay shield.1. Release the relays from the battery drip tray and remove them.2. Undo the nut fixing the air filter mounting bracket to the batterydrip tray.3. Undo the two fixing nuts (3a) and move the connections/electricalwiring mounting bracket (3b) aside.4. Release the accelerator cable from the fastening on the bracket.2018771
<anchor>0</anchor><span>Removing</span><icon><imageid>20</imageid></icon>1Refitting211. Unscrew the screw.2. Remove the frame (2a) and take it off the check clamps (2b).3. Unscrew the screws.4. Remove the speedometer/odometer (4a) from from support and moveit.5. Disconnect the electric connections (5a, 5b).2018847
5560B03
<anchor>0</anchor><span>Removing</span><icon><imageid>20</imageid></icon>1Refitting211. Unscrew the screw.2. Remove the frame (2a) and take it off the check clamps (2b).3. Unscrew the screws.4. Extract the speedometer (4a) from the support (4b) e move it.5. Disconnect the electric connections (5a, 5b).2018848
5560B06
<anchor>0</anchor><span>Removing</span><icon><imageid>20</imageid></icon>1Refitting21For the replacement of lampsof the speedometer/odometer proceed as follows.3238496-5560B02kilometre/mileometer - r r1. Turn and remove the lamp holder of the instrument lamp (1a) orthe lamp holder of the display lamp (1b).2. Remove the lamp from lamp holder. Pressure joint.2018849
<anchor>0</anchor><span>Removing</span><icon><imageid>20</imageid></icon>1Refitting211. Remove the component with theIU+2019 special tool .2. Disconnect the electric connection and remove the component.2018855
<anchor>0</anchor><span>Removing</span><icon><imageid>20</imageid></icon>1Refitting213238952-7055A43central front grille - r r3238951-7055A41RIGHT FRONT GRILLE - R.R. (leftand right) It is advisable to place the vehicle on a lift.1. Undo the bolts fixing the end of the front bumper.2. Release the wheel arch liner from the front bumper using thespecial tool in the area where the bolts were removed. 3. Working from the bottom, undo the two bolts securing the bumperto the wing.2018790
<anchor>0</anchor><span>Removing</span><icon><imageid>20</imageid></icon>1Refitting211. Undo the bolts.2. Remove control unit (2a) by disconnecting from electrical connection(2b).2018803
<anchor>0</anchor><span>Removing</span><icon><imageid>20</imageid></icon>1Refitting21Open the bonnet lid.
5540B48
<anchor>0</anchor><span>Removing</span><icon><imageid>20</imageid></icon>1Refitting21Open the bonnet lid.1. Rotate the cover in an anti-clockwise direction and extract it.2. Extract the bulb holder and bulb (press fit).3. Extract the bulb from the bulb holder.2018810
<anchor>0</anchor><span>Removing</span><icon><imageid>20</imageid></icon>1Refitting213238952-7055A43central front grille- r r . 3238951-7055A41RIGHT FRONT GRILLE - R.R. (right andleft). 767It is advisable to place the vehicleon a lift.1. Undo the bolts fixing the ends of the front bumper.2. Release the wheel arch liner from the front bumper, using thespecial tool, in the area where the bolts were removed. 3. Working from the bottom, undo the two bolts securing the bumperto the wing.2018811
<anchor>0</anchor><span>Removing</span><icon><imageid>20</imageid></icon>1Refitting21Open the boot lid and undothe two side bolts fixing the inner trim.2018778
5540A68
<anchor>0</anchor><span>Removing</span><icon><imageid>20</imageid></icon>1Refitting211. Open the boot lid and undo the bolts fixing the inner lining.2018781
5540A78
<anchor>0</anchor><span>Removing</span><icon><imageid>20</imageid></icon>1Refitting211. Open the boot lid and undo the bolts fixing the inner lining.2018784
5540A80
<anchor>0</anchor><span>Removing</span><icon><imageid>20</imageid></icon>1Refitting211. Open the trunk lid panel and unscrew the two clamping screwsof the light fender.2. Unloose the check tongs (2a) and extract the light holder (2b).3. Take the lights off from the light holder.(Bayonet joint)2018787
5540A94
<anchor>0</anchor><span>Removing</span><icon><imageid>20</imageid></icon>1Refitting211. Operating from the right side, by a screwdriver, and take thelight off.2. Disconnect the electrical connection.2018788
We use cookies on our website to give you the most relevant experience by remembering your preferences and repeat visits. By clicking “Accept All”, you consent to the use of ALL the cookies. However, you may visit "Cookie Settings" to provide a controlled consent.
This website uses cookies to improve your experience while you navigate through the website. Out of these, the cookies that are categorized as necessary are stored on your browser as they are essential for the working of basic functionalities of the website. We also use third-party cookies that help us analyze and understand how you use this website. These cookies will be stored in your browser only with your consent. You also have the option to opt-out of these cookies. But opting out of some of these cookies may affect your browsing experience.
Necessary cookies are absolutely essential for the website to function properly. This category only includes cookies that ensures basic functionalities and security features of the website. These cookies do not store any personal information.
Any cookies that may not be particularly necessary for the website to function and is used specifically to collect user personal data via analytics, ads, other embedded contents are termed as non-necessary cookies. It is mandatory to procure user consent prior to running these cookies on your website.
Čeština
Dansk
Deutsch
Ελληνικά
English
English
Español
Suomi
Français
Français
עברית
Hrvatski
Magyar
Italiano
日本語
한국어
Nederlands
Polski
Português
Română
Русский
Slovenčina
Slovenščina
Svenska
Türkçe
中文 (中国)
