CRUISE CONTROL
Cruise Control Wiring Diagram for Nissan Altima 2007
List of elements for Cruise Control Wiring Diagram for Nissan Altima 2007:
- (2.5l)
- (3.5l)
- 8p e6
- Accel/resume
- Accelerator pedal position sensor (above accelerator pedal, on bracket)
- Aps1
- Aps2
- Ascd brake switch (above brake pedal, on bracket)
- Ascd clutch switch
- Ascd steering switch
- Ascdsw
- Avcc1-aps1
- Avcc1-tps-b1
- Avcc2-aps2
- Bncsw
- Brake
- Cancel
- Coast/set
- Combination switch (spiral cable)
- Cvt
- E10
- E44
- E45
- E46
- E9 (lower left side of engine compt)
- Electric throttle control actuator (2.5l: integral with throttle body, on intake manifold) (3.5l: integral with throttle body)
- Engine control module (ecm) (left front of engine compt)
- F13
- F14
- Fuse 3 10a
- Fuse 7 10a
- Fuse block (j/b) (behind left end of dash)
- Gnd
- Gnda-aps1
- Gnda-aps2
- Gnda-ascdsw
- Gnda-tps-b1
- Hot at all all times
- Hot in on or start
- Joint connector e06 (behind left end of dash)
- Joint connector f04 (3.5l) joint connector f01 (2.5l) (left front of engine compt)
- Junction block
- M/t
- M30
- M88
- Main
- Motor1-b1
- Motor2-b1
- Nca
- Pnk
- Red
- Sensor
- Sensor 1
- Sensor 2
- Stop lamp switch (above brake pedal, on bracket)
- Throttle control motor
- Throttle position
- Tps1-b1
- Tps2-b1