ENGINE PERFORMANCE – Nissan Cube S 2012 – SYSTEM WIRING DIAGRAMS

ENGINE PERFORMANCE

1.8L

1.8L, Engine Performance Wiring Diagram (1 of 3) for Nissan Cube S 2012

List of elements for 1.8L, Engine Performance Wiring Diagram (1 of 3) for Nissan Cube S 2012:

• (top of engine)
• (top of engine) condenser
• Af heater gnd
• Aps1
• Aps2
• Ascd brake sw
• Ascd sw
• Can-h
• Can-l
• Computer data lines system
• Cruise control system
• E105
• E16
• E38
• Ecm (left rear of engine room)
• Evap
• F6 (front of engine)
• Fpr
• Fuel injector 1
• Fuel injector 2
• Fuel injector 3
• Fuel injector 4
• Fuse 10a
• Fuse block (j/b) (left side of dash)
• Ground
• Hot at all times
• Ign 1
• Ign 2
• Ign 3
• Ign 4
• Ign sw
• Ignition coil 1 (w/ power transistor) (top of engine)
• Ignition coil 2 (w/ power transistor) (top of engine)
• Ignition coil 3 (w/ power transistor) (top of engine)
• Ignition coil 4 (w/ power transistor) (top of engine)
• Inj 1
• Inj 2
• Inj 3
• Inj 4
• K-line
• M77
• Motor (open)
• Motrly
• Nca
• O2hr
• Oil temp sens
• Plug spark
• Pnk
• Pnp sig
• Pwr sply
• Pwr sply for ecm
• Red
• Scv 1
• Scv 2
• Sens gnd
• Sens pwr sply
• Sns gnd
• Ssoff
• Stop lamp switch (left side of dash)
• Stop lp sw
• Vscv

1.8L, Engine Performance Wiring Diagram (2 of 3) for Nissan Cube S 2012

List of elements for 1.8L, Engine Performance Wiring Diagram (2 of 3) for Nissan Cube S 2012:

• (front of engine) intake valve timing control solenoid valve
• (right rear of vehicle) evap canister vent control valve
• Accelerator pedal position sensor (top of accelerator pedal assembly)
• Close
• Cpu
• E105
• E13
• E14
• E15
• Ecm relay
• Electric throttle control actuator (on throttle body)
• Engine oil temperature sensor (california)
• Except canada
• Fuel pump relay
• Fuse 10a
• Fuse 15a
• Fuse 20a
• Hot at all times
• Hot in on or start
• Hot w/ ignition relay energized
• Ipdm e/r (intelligent power distribution module engine room) (left rear of engine compt)
• M18
• M77
• M77 e105
• M79
• Open
• Pnk
• Red
• Sensor 1
• Sensor 2
• Throttle control motor
• Throttle control motor relay
• Throttle position sensor
• Tumble control valve actuator (california)
• Tumble control valve motor
• Tumble control valve position sensor
• W/ intelligent key
• W/o intelligent key

1.8L, Engine Performance Wiring Diagram (3 of 3) for Nissan Cube S 2012

List of elements for 1.8L, Engine Performance Wiring Diagram (3 of 3) for Nissan Cube S 2012:

• (left side of engine block) knock sensor
• (on engine intake air duct) mass airflow sensor (w/ intake air temperature sensor)
• (rear of cylinder head)
• (rear of engine room) evap canister purge volume control solenoid valve
• (top of fuel tank) fuel level sensor unit & fuel pump
• (top rear of engine) engine coolant temperature sensor
• A/f sens 1
• Air flow sens
• Air fuel ratio (a/f) sensor 1 (rear of engine room)
• Air temp sens
• B57
• Batt current sens
• Battery current sensor (cvt) (near battery)
• Camshaft position sensor (phase)
• Can-h
• Can-l
• Combination meter
• Computer data lines system
• Crankshaft position sensor (pos) (lower front of engine)
• Cvt
• E105
• Ecm (left rear of engine room)
• Evap control system pressure sensor (near evap canister)
• Except canada
• F1 e8
• Fuel pump
• Fuel tank temperature sensor
• Fuse 10a
• Fuse block (j/b) (left side of dash)
• Heated oxygen sensor 2 (in exhaust between three way catalysts)
• Hot in on or start
• Iat sensor
• Intake valve
• Knk snsr
• M/t
• M18
• M77
• M77 e105
• M79
• M79 b4
• Malfunction indicator lamp
• O2sr
• Park/neutral position switch (top of transmission)
• Phase
• Pnk
• Position sns (gnd)
• Pwr sply for ecm
• Qa-
• Red
• Ref prs sens
• Refrigerant pressure sensor (under alternator)
• Scvpos
• Sens gnd
• Sens gnd fuel level
• Sens pwr sply
• Sens sig fuel level
• Shield
• Starting/ charging system
• Temp sens
• Tps1
• Transmission range switch (top of transmission)