SUPPLEMENTAL RESTRAINTS – Lincoln Navigator 2000 – SYSTEM WIRING DIAGRAMS

SUPPLEMENTAL RESTRAINTS

Supplemental Restraint Wiring Diagram for Lincoln Navigator 2000

List of elements for Supplemental Restraint Wiring Diagram for Lincoln Navigator 2000:

• (lower left inner kick panel) g200
• (main harness, near breakout to central junction box) s2002
• (main harness, near breakout to ground, upper left inner kick panel) s208
• Air bag indicator
• Air bag indicator lamp
• Air bag sliding contact
• C2004
• C2005
• C238
• C239
• C242
• C243
• Central junction box (under left side of dash)
• Data link connector (dlc) (partial) (under center of dash)
• Diagnostic output
• Driver air bag
• Driver air bag feed
• Driver air bag return
• Driver side air bag
• Driver side air bag feed
• Driver side air bag return
• Driver side sensor feed
• Driver side sensor return
• Expedition w/ side air bags
• Expedition w/o side air bags
• Expedition w/o side air bags & navigator
• Expedition w/side air bags
• Fuse 22 10a
• Fuse 30 30a
• Generic electronic module (gem) (behind left side of dash)
• Ground
• Hot in run
• Hot in run or start
• Instrument cluster
• Left primary crash sensor (in left front of engine compartment)
• Nca
• Pass air bag feed
• Pass air bag return
• Pass side air bag feed
• Pass side air bag return
• Pass side sensor feed
• Pass side sensor return
• Passenger air bag
• Passenger side air bag
• Pin shorting bar is engaged when module connector is disconnected: (shorting bar connected between following pins: 3-4, 6-7, 20 & 21 for conn c2005 2-3 & 5-6 for conn c2004
• Power
• Restraints control module (rcm) (behind right side of dash)
• Right primary crash sensor (in right front of engine compartment)
• S229 (main harness, near breakout to instrument cluster)
• Shorting bar
• Tone request
• Tone request input