CRUISE CONTROL – Ford Ranger 2008 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Ford Ranger 2008

List of elements for Cruise Control Wiring Diagram for Ford Ranger 2008:

• 10a
• A/t
• Brake pedal position switch (behind left side of dash, on brake pedal support)
• C175b
• C175t
• C218a
• C218c
• C220a
• C220b
• C2280a
• C2280b
• C2280d
• Cbp20
• Ccb15
• Ces03
• Ces09
• Clockspring
• Clutch pedal position switch (behind left side of dash, top of brake pedal support)
• Coast
• Deactivator switch (under left side of dash)
• Fuse 20
• Fuse 26
• Fuse 32
• Fuse 5a
• G105 (right rear of engine compartment)
• G204 (under front of center console)
• G205
• G301 (under driver's seat)
• Gd123
• Gnd
• Horns system
• Hot at all times
• Hot in run
• Illumination
• Instrument cluster
• Interior lights system
• Low current board
• M/t
• Micro- processor
• Off
• Oss
• Output shaft speed (oss) sensor (left rear of transmission)
• Powertrain control module (pcm) (right rear of engine compartment)
• Re406
• Red
• Res08
• Rest
• Resume
• Ret04
• S102 (3.0l: in engine control sensor & fuel charge harness, near breakout to c110) (except 3.0l: in engine control sensor & fuel charge harness, near breakout to g106)
• S128
• S203
• S212
• S214
• S215
• S220
• S226 (in main harness, near breakout to front cigar lighter)
• Sense
• Set
• Set ind
• Sig rtn
• Smart junction box (sjb) (right kick panel)
• Speed control ind
• Speed control on/off switch
• Speed control servo (right rear of engine compartment)
• Speed control set/ resume switch
• Vbatt
• Ves10
• Vmc05
• Vpwr
• Vref
• Vss