CRUISE CONTROL
3.8L
3.8L (VIN L), Cruise Control Wiring Diagram for Oldsmobile Silhouette 1995
List of elements for 3.8L (VIN L), Cruise Control Wiring Diagram for Oldsmobile Silhouette 1995:
- (below right side of i/p, behind convenience center)
- (engine compartment, mounted to left wheelhouse)
- (sps)
- 5 volt ref
- Brake switch assembly (mounted to brake pedal support)
- Brk in (vent&vac cntls)
- Btsi/tcc switch
- C 1995 vftc
- C11
- C12
- C14
- Closed
- Connected to throttle linkage
- Convenience center
- Cruise control release switch
- Cruise control servo
- Cruise control switch
- Cruise control vacuum release valve
- Cruise on input
- Engine controls system (3.8l vinl) & a/c compressor controls system
- F11
- F16
- Fuse block
- G120 (right side of engine, below electronic ignition module)
- Hot in run
- Hot in run, bulb test, or start
- Ign fuse 15a
- Nca
- Off
- Pnk
- Powertrain control module (pcm)
- R/a
- Resume/accel input
- Sensor return
- Servo posit sens (hi)
- Servo posit sens (lo)
- Servo position sensor
- Set switch
- Set/coast input
- Tan
- Throttle posit sens input
- Throttle position (tp) sensor (mounted to sequential fuel injection unit)
- Vac valve cntl
- Vacuum motor
- Vacuum release port
- Vacuum source
- Vacuum valve
- Variable a/c signal
- Vehicle speed sensor (mounted to top of transaxle)
- Vent
- Vent valve
- Vent valve cntl
- Vss input (hi)
- Vss input (lo)