SUPPLEMENTAL RESTRAINTS – Chevrolet Corvette 1996 – SYSTEM WIRING DIAGRAMS

SUPPLEMENTAL RESTRAINTS

Supplemental Restraint Wiring Diagram for Chevrolet Corvette 1996

List of elements for Supplemental Restraint Wiring Diagram for Chevrolet Corvette 1996:

• 10.2k
• 2.49k
• 8.45k
• A10
• A11
• A12
• Air bag fuse 34 15a
• Air bag ind
• B10
• B11
• B12
• Central control module (behind center i/p)
• Cluster fuse 27 5a
• Crank air bag fuse 9 5a
• Crank input
• Data link connector (left side of i/p)
• Diagnostic energy reserve module (derm) (behind right side of i/p, left of i/p fuse block)
• Driver 36v lr
• Driver inflator module (middle of steering wheel)
• Driver information center
• Driver side "high"
• Driver side "low"
• Driver source sense
• Dual pole arming sensor (behind center of i/p)
• F10
• G114 (left rear of engine)
• G114 (left rear of engine)
• G200 (left kick panel)
• Ground
• Hot in run, bulb test or start
• Hot in start
• I/p fuse block
• Ign 1
• Left forward discriminating sensor (under battery, on frame rail)
• Nca
• Pass 36v lr
• Pass side "high"
• Pass side "low"
• Pass source sense
• Passenger inflator module (right side of i/p)
• Pnk
• Redundant ind ground
• Redundant ind ign 1
• Right forward discriminating sensor (below blower motor housing, on frame rail)
• Seat belt input
• Seat belt sw
• Seat belt sw signal
• Shorting bar
• Sir coil assembly (top of steering column)
• Sir ind
• Tan