WARNING SYSTEMS — Infiniti Q45 2005 — SYSTEM WIRING DIAGRAMS

WARNING SYSTEMS

Chime Wiring Diagram for Infiniti Q45 2005

List of elements for Chime Wiring Diagram for Infiniti Q45 2005:

• (behind dash, left of steering column)
• (behind left side of dash) m24
• 15a
• 1st
• 20b
• 2nd
• 7c m1
• Auto
• B17 (under left front door sill)
• Bat
• Belt ind
• Body control module (behind left kick panel)
• Buckle sw
• Chime
• Combination meter
• Combination switch (lighting switch)
• Door ind
• Door sw (dr)
• Dr warn lamp
• Exterior lights system
• Front door switch (driver side)
• Front power seat (driver side)
• Fuse 1 10a
• Fuse 10a
• Fuse 3 10a
• Fuse 6 10a
• Fuse block (j/b) 1 (behind left end of dash)
• Fuse block (j/b) 2 (behind right kick panel)
• Gnd
• Headlamp battery saver control unit
• Hot at all times
• Hot in on or start
• Ign sw
• Ignition
• Indicator
• Key sw
• Key switch & key lock solenoid
• Lt sw (1st)
• M115 (behind right side of dash)
• M145
• M33
• M34
• M43
• Off
• Pre-crash seat belt control unit (right side of luggage compt)
• Seat belt buckle switch
• Seat blt sw
• T/l sw1
• T/l sw2
• Tail/l rly
• Unified meter control unit
• Warning chime

Tire Pressure Monitoring Wiring Diagram for Infiniti Q45 2005

List of elements for Tire Pressure Monitoring Wiring Diagram for Infiniti Q45 2005:

• (behind left
• 19b
• Acc
• Antenna
• Antenna signal
• Batt
• Combination
• Commi (bus+)
• Commi (bus-)
• Commi (gnd)
• Computer data lines system
• Diag-id input
• End of dash)
• Exterior lights system
• Fuse 10a
• Fuse block (j/b) 1
• Ground
• Hazard
• Hot at all times
• Hot in acc or on
• Hot in on or start
• Ign
• Led
• Low tire pressure warning control unit (behind center of dash)
• Low voltage detection circuit
• M25 (behind left side of dash)
• M41
• M424
• M43
• M84
• Meter
• Navigation system
• Nca
• Pnk
• Speed input
• Tire pres- sure ind
• Tire pressure warning check switch
• Unified meter control unit