CRUISE CONTROL — Chrysler PT Cruiser 2001 — SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Chrysler PT Cruiser 2001

List of elements for Cruise Control Wiring Diagram for Chrysler PT Cruiser 2001:

• on/off
• A/t
• Brake lamp switch
• Cancel
• Clockspring
• Clutch interlock signal
• Clutch pedal position switch
• Control module)
• Cruise
• Data link connector (under left side of dash near kick panel)
• Dump
• Fuse 10 10a
• Fuse block (left side of dash)
• Fused ignition switch output
• G100 (front of left fender)
• G101 (right front inner fender)
• G206 (center of i/p)
• Hot in run/start
• Instrument cluster
• M/t
• Park/ neutral position
• Pci bus
• Pnk
• Receive
• Res/accel
• S113 (near t/o for left fender area)
• S121
• S126 (near data link connector)
• S137 (near t/o for trans control module)
• S139 (near t/o for left front fog lamp)
• S201 (near t/o for brake shift interlock solenoid)
• S224 (rke)
• S239
• Sci
• Set/coast
• Speed control servo
• Speed control switch signal
• Speed control vacuum solenoid
• Speed control vent solenoid control
• Speed sensor signal
• Tan/ red
• Trans control module
• Trans range sensor (atx)
• Transmit
• Vacuum
• Vehicle speed control switch
• Vehicle speed sensor
• Vent