CRUISE CONTROL
Cruise Control Wiring Diagram for Mitsubishi Outlander ES 2008
List of elements for Cruise Control Wiring Diagram for Mitsubishi Outlander ES 2008:
- (3.0l)
- (behind left side of dash) g6
- (behind left side of dash) transmission control module
- (main)
- (or pnk)
- (or red)
- (sub)
- (under steering wheel) clock spring
- 2.4l
- 3.0l
- Accelerator pedal position sensor (top of accelerator pedal bracket)
- Anti-lock brakes system
- B10
- B11
- C-202
- C-204
- C-301
- C-304
- C-312
- C-313
- C-317
- C-37
- C-37 (2.4l)
- C-38
- Can drive circuit
- Can transceiver circuit
- Cancel
- Circuit face inter-
- Combination meter
- Computer data lines system
- Cpu
- Cruise control switch
- Cruise ind
- Engine compartment relay box
- Engine control module (left rear corner of engine compt)
- Etacs-ecu (behind left side of dash)
- Fuse 15a
- Fuse 20a
- Fuse 7.5a
- G14 (left front of engine compt)
- G19 (under left end of dash)
- Hall ic
- Hot at all times
- Hot w/ ig1 relay energized
- Hot w/ mfi relay energized
- Ill
- Interface circuit
- Led drive circuit
- Off
- Output shaft speed sensor (top right of transaxle)
- Pnk
- Red
- Res/acc
- Secondary pulley speed sensor (top of transaxle)
- Set/cst
- Shift interlock system
- Sound systems
- Stoplight switch (above brake pedal, on bracket)
- Throttle actuator control motor
- Throttle body assembly (right rear of engine)
- Throttle valve control servo relay
- Transmission range switch (top of transaxle)
- Transmissions system