ANTI-THEFT – Hummer H2 2007 – SYSTEM WIRING DIAGRAMS

ANTI-THEFT

Forced Entry Wiring Diagram for Hummer H2 2007

List of elements for Forced Entry Wiring Diagram for Hummer H2 2007:

• A12
• Ajar
• Ajar input
• Ajar switch
• B12
• Battery
• Body control module (bcm) (on top left side of dash, above i/p fuse block)
• D12
• Door ajar sw sig
• Door sw lo ref
• Driver door latch assembly (at rear of driver door)
• Driver door module (ddm) (behind driver's door panel)
• Except sut
• Exterior lights system
• G200 (on left side of dash, near left kick panel)
• G302 (at left inner center "b" pillar)
• G306 (at right inner center "b" pillar)
• G320 (left side of midgate)
• G410
• Gate ajar sw
• Ground
• Headlights ctrl
• Headlights system
• Horn rly ctrl
• Horns system
• Hot at all times
• I/p fuse block (on lower left side of dash)
• I/p junction block (on lower right side of dash) c7
• I/p relay block (on left side of dash, near left kick panel)
• Ign
• Instrument panel cluster (ipc)
• Key sw sig
• Key switch
• Left liftgate ajar switch (at lower left side of liftgate)
• Left midgate latch (lh side of midgate, at latch assembly)
• Left rear door latch assembly (at rear of door)
• Logic
• Lr door ajar sw
• Midgate ajar sig
• Midgate control module (mcm) (center of midgate assembly, attached to window regulator assembly)
• Park rly ctrl
• Passenger door latch assembly (at rear of passenger door)
• Passenger door module (pdm) (in passenger door)
• Right liftgate ajar switch (at lower right side of liftgate)
• Right midgate latch (rh side of midgate, at latch assembly)
• Right rear door latch assembly (at rear of door)
• Rr door ajar sw
• S310
• S339
• S390
• S901
• S902 (at lower right side of liftgate, 6.5 cm from right liftgate ajar switch junction to liftgate harness)
• Security indicator
• Serial data
• Splice pack sp205 (in i/p harness, on left side of dash, near footwell courtesy lamp)
• Splice pack sp410 (inside right rear cargo area, at middle of right rear "d" pillar)
• Sut
• Tan
• Tbc batt fuse 10a
• Underhood fuse block (at left side of engine compt, near battery)
• Wiper/washer system

Passlock Wiring Diagram for Hummer H2 2007

List of elements for Passlock Wiring Diagram for Hummer H2 2007:

• (at left side of engine)
• (at right side of engine)
• 12v ref
• A11
• A12
• B12
• Battery
• Body control module (bcm) (on top left side of dash, above i/p fuse block)
• Connector (dlc) (under left side of dash, below steering column)
• D12
• Data link
• Fuel injector 1
• Fuel injector 2
• Fuel injector 3
• Fuel injector 4
• Fuel injector 5
• Fuel injector 6
• Fuel injector 7
• Fuel injector 8
• G200 (on left side of dash, near left kick panel)
• Ground
• Hot at all times
• Hot in run & start
• I/p relay block (on left side of dash, near left kick panel)
• Ign
• Ign 1 volt
• Inj 1 ctrl
• Inj 2 ctrl
• Inj 3 ctrl
• Inj 4 ctrl
• Inj 5 ctrl
• Inj 6 ctrl
• Inj 7 ctrl
• Inj 8 ctrl
• Instrument panel cluster (ipc)
• Logic
• Low ref
• Passlock electronics
• Passlock sensor (part of ignition lock cylinder, in steering column assembly)
• Pnk
• Powertrain control module (pcm) (on left front of engine compt)
• Sec sens sig
• Security indicator
• Serial data
• Splice pack sp205 (in i/p harness, on left side of dash, near footwell courtesy lamp)
• Tbc batt fuse 10a
• Tbc ign 1 fuse 10a
• Underhood fuse block (at left side of engine compt, near battery)