SUPPLEMENTAL RESTRAINTS – Chevrolet Camaro 1994 – SYSTEM WIRING DIAGRAMS

SUPPLEMENTAL RESTRAINTS

Supplemental Restraint Wiring Diagram for Chevrolet Camaro 1994

List of elements for Supplemental Restraint Wiring Diagram for Chevrolet Camaro 1994:

• (chevrolet) (pontiac)
• (not used)
• (pontiac) (chevrolet)
• 10.2k
• 2.49k
• 8.45k
• A10
• A11
• A12
• A7 c16
• Air bag fuse 1 15a
• Air bag ind
• Audio alarm module
• B10
• B11
• B12
• Computer data lines
• Convenience center (left of steering column, bottom of i/p carrier)
• Crank fuse 16 3a
• Crank input
• D13 a5
• Diagnostic energy reserve module (derm) (behind right side of i/p compt)
• Driver 36v lr
• Driver inflator module (mounted on steering wheel)
• Driver side "high"
• Driver side "low"
• Driver source sense
• Dual pole arming sensor (floor tunnel bracket, under console)
• Forward discriminating sensor (center of front end tie bar, near hood latch)
• G103 (top of right shock tower)
• G200 (near base of left "a" pillar, bolted to i/p mounting stud behind kick panel)
• Gages fuse 9 15a
• Ground
• Hot in run, bulb test or start
• Hot in start
• I/p fuse block
• Ign (not used)
• Ign 1
• Instrument cluster
• Nca
• Pass 36v lr
• Pass side "high"
• Pass side "low"
• Pass source sense
• Passenger compt discriminating sensor (upper dash, right of steering column)
• Passenger inflator module (right side of i/p, above i/p compt)
• Pnk
• Redundant ind ground
• Redundant ind ign 1
• Seat belt input
• Seat belt sw
• Seat belt sw signal
• Serial data
• Shorting bar
• Sir coil assembly (top of steering column)
• Sir ind
• Tan