STARTING/CHARGING – Audi TT Quattro 2014 – SYSTEM WIRING DIAGRAMS

STARTING/CHARGING

2.0L TURBO

2.0L Turbo, Charging Wiring Diagram for Audi TT Quattro 2014

List of elements for 2.0L Turbo, Charging Wiring Diagram for Audi TT Quattro 2014:

• Battery
• Battery interrupt igniter
• Battery jump start terminal (if equipped)
• Battery monitoring control module (on battery in luggage compt)
• Computer data lines system
• Convertible
• Display unit
• Fuse 175a
• Fuse panel d
• Fuse panel sa (left side of engine compt)
• G40 (coupe: below right side of rear seat bench) (convertible: under
• Generator & voltage regulator
• Instrument cluster control module
• Nca
• Starter
• T4a
• Top box)

2.0L Turbo, Starting Wiring Diagram for Audi TT Quattro 2014

List of elements for 2.0L Turbo, Starting Wiring Diagram for Audi TT Quattro 2014:

• (on left front long member) g672
• 11a
• 31a
• A/t
• Battery
• Battery interrupt igniter
• Battery jump start terminal (if equipped)
• Cdma
• Ceta
• Charging circuit
• Clutch position sensor (m/t) (on clutch master cylinder)
• Computer data lines system
• Direct shift gearbox (dsg) mechatronic
• Engine control module (center rear of engine compt)
• Fuse 40a
• Fuse 5a
• Fuse carrier
• Fuse panel d
• Fuse panel sb (left side of engine compt)
• Fuse panel sc (left side of dash)
• G40 (coupe: below right side of rear seat bench) (convertible: under convertible top box)
• G44 (lower left "a" pillar)
• Ignition/ starter switch
• Lock
• M/t
• Nca
• Red
• Run
• Selector lever sensor system control module
• Start
• Starter
• Steering column electronics system control module (at steering column)
• T10p
• T12i
• T20c
• T20e
• T52b
• T52c
• T94
• Vehicle electrical system control module (left side of dash)