STARTING/CHARGING – Buick Enclave CX 2009 – SYSTEM WIRING DIAGRAMS

STARTING/CHARGING

Charging Wiring Diagram for Buick Enclave CX 2009

List of elements for Charging Wiring Diagram for Buick Enclave CX 2009:

• 200a
• Air bag fuse 10a
• Battery
• Battery current sensor (behind front passenger's seat)
• Body control module (bcm) (under left side of dash)
• Charge ind
• Computer data lines system
• Current sens sig
• Driver information center (dic)
• Engine control module (ecm) (left side of engine)
• G301 (behind left kick panel)
• G305 (near battery)
• Generator f
• Generator field
• Generator inline fuse
• Generator turn on
• Gnd
• Hi spd gmlan
• Hot w/ ign relay energized
• I/p fuse block (behind right end of dash)
• Instrument panel cluster (ipc)
• J215
• Logic
• Low ref
• Pnk
• Power distribution system
• Red
• Rvc snsr fuse 15a
• Sply volt
• Starter motor
• Tan
• Underhood fuse block (above right front wheelwell)
• Volt

Starting Wiring Diagram for Buick Enclave CX 2009

List of elements for Starting Wiring Diagram for Buick Enclave CX 2009:

• Acc
• Automatic transmission
• Automatic transmission internal mode switch (ims)
• Battery
• Battery current sensor (behind front passenger's seat)
• Body control module (bcm) (under left side of dash)
• Charging circuit
• Computer data lines system
• Control solenoid valve assembly
• Crnk relay
• Engine control module (ecm) (left side of of engine)
• G110 (right front of engine, mounted to cylinder head)
• G305 (near battery)
• Gnd
• Ground distribution system
• Hi spd gmlan
• Ign
• Ignition switch
• Off
• P/n sw
• Power distribution system
• Red
• Rly coil ctrl
• Run
• Start
• Starter motor
• Strtr fuse 40a
• Tan
• Transmission control module
• Underhood fuse block (above right front wheelwell)