STARTING/CHARGING – Buick LeSabre Custom 2002 – SYSTEM WIRING DIAGRAMS

STARTING/CHARGING

Charging Wiring Diagram for Buick LeSabre Custom 2002

List of elements for Charging Wiring Diagram for Buick LeSabre Custom 2002:

• (not used) a
• (under right rear seat, right of battery on floor pan) g305
• A11
• A12
• B12
• Battery
• Battery volt indicator
• Battery volts high
• Battery volts low
• Check charge system
• Dash integration module (dim) (behind right side of dash, under sound insulator)
• Dim fuse 10a
• Driver information center
• E11
• Flat wire
• Gen term f mon
• Gen term l ctrl
• Generator l
• Hot at all times
• Instrument panel cluster
• Nca
• Powertrain control module (pcm) (in air cleaner housing)
• Rear fuse block (under left rear seat)
• Red
• S217
• Serial class 2 data
• Serial data class 2
• Starter solenoid
• System voltage measurement
• Underhood fuse block (right front side of engine compartment)

Starting Wiring Diagram for Buick LeSabre Custom 2002

List of elements for Starting Wiring Diagram for Buick LeSabre Custom 2002:

• Acc
• Battery
• Computer data lines system
• G305 (under right rear seat, right of battery on floor pan)
• Ground distribution system (dash integration module (dim))
• Hold in coil
• Hot in run & start
• Ign crank sense
• Ign sw fuse 15a
• Ignition switch
• Lock
• Nca
• Note: refer to power distribution system: ign-1 relay
• Pcm (ign) fuse 10a
• Power distribution system
• Powertrain control module (pcm) (in air cleaner housing)
• Pull in coil
• Rear fuse block (under left rear seat)
• Run
• Serial data class 2
• Start
• Start 1 relay
• Start circuit breaker 30a
• Starter ctrl
• Starter motor
• Starter solenoid
• Starting/ charging system (charging circuit)
• Underhood fuse block (right front side of engine compartment)
• Unlock