STARTING/CHARGING – Buick Regal LS 1997 – SYSTEM WIRING DIAGRAMS

STARTING/CHARGING

Charging Wiring Diagram for Buick Regal LS 1997

List of elements for Charging Wiring Diagram for Buick Regal LS 1997:

• (lower left front of engine, on transaxle stud)
• (not used) p
• (right side of eng. compt., base of battery)
• A8 c1
• B12
• B35
• Battery
• Charge ind
• Class 2 data
• Cluster fuse 10a
• Fuse block
• Fusible link (10 ga- rust)
• G101
• G129
• Gen fuse 10a
• Generator
• Generator control
• Generator f terminal
• Hot at all times
• Hot in run, bulb test or start
• Instrument cluster
• Pnk
• Power distribution system
• Powertrain control module (air cleaner assembly)
• Red
• Solid state
• Splice pack (sp205) (below dash, right of steering column)
• Starter solenoid
• Underhood electrical center

Starting Wiring Diagram for Buick Regal LS 1997

List of elements for Starting Wiring Diagram for Buick Regal LS 1997:

• (lower left front of engine, on transaxle stud)
• Accy
• B red
• B12
• Battery
• Bulb test
• Crank maxifuse 40a
• Crank relay
• Crank signal
• Crank signal fuse 10a
• F10
• Fuse block
• G101
• G129
• Hold- in coil
• Hot at all times
• Ign main 1 maxifuse 40a
• Ignition switch
• Lock
• Off
• Pcm- bcm fuse 10a
• Pnk
• Powertrain control module (air cleaner assembly)
• Pull- in coil
• Remote battery stud
• Run
• S228
• S234
• Start
• Starter enable relay driver
• Starter motor
• Starter solenoid
• Transaxle range switch (on transaxle)
• Underhood electrical center