STARTING/CHARGING – Chevrolet Beretta 1995 – SYSTEM WIRING DIAGRAMS

STARTING/CHARGING

Charging Wiring Diagram for Chevrolet Beretta 1995

List of elements for Charging Wiring Diagram for Chevrolet Beretta 1995:

• (16 ga-black) red
• (left front of engine compt, behind battery)
• (left rear of engine, on transaxle stud)
• (not used) p
• (solid state)
• (vin 4)
• (vin 4) (vin a)
• (vin m)
• 10a
• 1995 vftc c
• 20a
• Base cluster only
• Bat
• Battery
• Charge ind.
• Field (rotor)
• Fuse 4
• Fuse 9
• Fuse block
• Fusible link
• Fusible link (14 ga- gray)
• Fusible link (16 ga- rust)
• Fusible link (20 ga-gray) (22 ga-rust)
• G100
• G114
• Generator (upper right front of engine)
• Ground distribution
• Hot in run
• Hot in run, bulb test or start
• Instrument cluster
• Pnk
• Power distribution
• Rectifier bridge
• Red
• Regulator
• Starter solenoid (lower left rear of engine)
• Stator
• Turn on input
• Voltage sensing input

Starting Wiring Diagram for Chevrolet Beretta 1995

List of elements for Starting Wiring Diagram for Chevrolet Beretta 1995:

• (left front of engine compt, behind battery)
• (vin m & 4- left rear of engine, on transaxle stud)
• *l4 vin 4 **v6 vin m
• 1995 vftc c
• A/t
• Accy
• Battery
• Bulb test
• Clutch pedal position switch (left of i/p, left of clutch pedal)
• F * **
• Fusible link (16 ga- black)
• Fusible link (20 ga-gray) (vin 4) (22 ga-rust) (vin m)
• G * **
• G100
• G114
• Ground distribution
• Hold-in winding
• Ignition switch
• Lock
• M/t
• Off
• Park/ neutral position switch (top right of transaxle)
• Power distribution
• Pull-in winding
• Red
• Release relay
• Run
• Solenoid contacts
• Start
• Starter motor
• Starter solenoid (lower left rear of engine)