STARTING/CHARGING — Chevrolet Lumina 2000 — SYSTEM WIRING DIAGRAMS

STARTING/CHARGING

Charging Wiring Diagram for Chevrolet Lumina 2000

List of elements for Charging Wiring Diagram for Chevrolet Lumina 2000:

• (not used)
• Battery
• C16
• Charge warning indicator
• Control
• Fuse 10a
• Fuse block (on right side of dash)
• Fusible link (10 ga- rust)
• G108 (left side of radiator support)
• G129 (on transaxle stud)
• Generator l
• Hot in run, bulb test & start
• Ign
• Indicator lamp c1
• Instrument cluster
• P b+
• Pnk
• Power distribution system
• Powertrain control module (pcm) (on right side of engine compartment, forward of strut tower)
• Red
• Starter solenoid

Starting Wiring Diagram for Chevrolet Lumina 2000

List of elements for Starting Wiring Diagram for Chevrolet Lumina 2000:

• (dash harness, at left side of instrument panel compartment, approx 4 cm (2 in) from theft deterrent module breakout) s224
• Acc
• Batt
• Battery
• Bulb test
• Engine wiring harness junction block 2 (forward of left front strut tower)
• Fuse 5a
• Fuse block (on right side of dash)
• Fusible link (10 ga- rust)
• G108 (left side of radiator support)
• G129 (on transaxle stud)
• Generator
• Hold- in coil
• Ign sw 1 maxifuse 50a
• Ignition switch
• Lock
• Off
• Park/neutral position (pnp) switch
• Power distribution system
• Pull- in coil
• Red
• Remote battery stud
• Run
• Start
• Starter enable
• Starter motor
• Starter solenoid
• Theft deterrent module (behind dash, above glove box)
• Theft deterrent relay (under right side of dash, above glove box)