STARTING/CHARGING – Chevrolet Monte Carlo LS 2003 – SYSTEM WIRING DIAGRAMS

STARTING/CHARGING

Charging Wiring Diagram for Chevrolet Monte Carlo LS 2003

List of elements for Charging Wiring Diagram for Chevrolet Monte Carlo LS 2003:

• (not used)
• A/c rly (cmpr) fuse 10a
• Battery
• Charge warning indicator (red)
• Class 2 serial data
• Class 2 serial data c1
• Computer data lines
• Fusible link (10 ga- rust)
• G113 (on transaxle stud, near starter)
• Generator
• Generator turn on signal c2
• Hot at all times
• Hot in acc, on or start
• Instrument panel cluster
• Left i/p junction block (left side of dash, behind access panel)
• Pcm/bcm/clstr fuse 10a
• Power distribution system
• Powertrain control module (pcm) (in air cleaner box)
• Red
• Splice pack sp205 (next to left i/p accessory wiring junction block wiring harness, taped on harness)
• Starter solenoid
• Underhood junction block (top) (on front of right strut tower)

Starting Wiring Diagram for Chevrolet Monte Carlo LS 2003

List of elements for Starting Wiring Diagram for Chevrolet Monte Carlo LS 2003:

• Abs/pcm fuse 10a
• Acc
• B10
• Batt
• Battery
• C10
• Class 2 serial data
• Crank relay
• Crank relay ctrl
• Crank request
• Data link connector (dlc) (partial) (below left side of dash, right of steering column)
• Fusible link (10-ga rust)
• G113 (on transaxle stud, near starter)
• Generator
• Hold- in coil
• Hot at all times
• Hot in on or start
• Ignition switch
• Left i/p junction block (left side of dash, behind access panel)
• Off
• Pcm (crank) fuse 10a
• Pnk
• Power distribution system
• Powertrain control module (in air cleaner box)
• Pull- in coil
• Red
• Splice pack sp205 (next to left i/p accessory wiring junction block, taped on harness)
• Start
• Starter motor
• Starter solenoid
• Underhood junction block (top) (on front of right strut tower)